Your cart is empty.
Your cart is empty. Replaces Factory # 35340-MA5-671, 35340-ML7-000, and 35340-MM5-600.
Factory-quality front brake light switches.
Atom O.
Reviewed in the United States on February 11, 2025
Perfect replacement on my 1982 Honda GL1100. I couldn't be happier. Built quality is solid
Ken G.
Reviewed in the United States on September 17, 2022
This replaced a faulty front brake light switch on my 1986 Honda Helix. It fit perfectly and works like the original. Fast delivery and had me back on the road in no time!
Don M.
Reviewed in the United States on December 3, 2021
Used this switch on a Ymaha that wasn't listed as one othe bikes it would fir.The switch looked like the one on the bike and wasn' that expensive so ordered it, worked and fit perfectly. Looked just like the original.I suspect the switch is used on a lot of Japanese bikes.
Jem
Reviewed in the United States on April 27, 2021
Great for the price worked wonderful very easy to install Would definitely recommend product
Roy K
Reviewed in the United States on August 7, 2020
Unfortunately, the switch (although works) is quite delicate. Just actuating the switch with my fingers with minimal pressure, the unit clearly flexed and started to open at the seam. I could visibly see the insides through the crack (says a bunch because I really need reading glasses). The factory that was non functional did not have this issue. I will be ordering a Honda OEM switch, but this one will get me by until then. I'll keep it as a spare, but I won't trust it long term.
B. Westman
Reviewed in the United States on August 5, 2019
Just like everyone else said, the prongs a little closer than the OEM part, but that makes zero difference in how it works. My 2002 Honda Shadow failed inspection this year due to a rear brake light, which I discovered was just this switch. I ordered the switch, replaced it myself in a matter of minutes (I'm a 55 year old lady), and was back at the shop to get my inspection sticker in no time at all. Works great and was super simple to install.
Dayana
Reviewed in the United States on December 25, 2019
Works like a charm. Installed on my 02 Shadow Ace 750 with an aftermarket brake master cylinder. Screwed right in. As others have mentioned, the contacts are a bit close but I was able to bend them a bit with needle nose pliers.
Customer
Reviewed in the United States on June 5, 2018
Works great on a 2007 cbr600rr it's slightly different than the OEM switch 1 side is smooth and the other has a single raised locator to keep the switch in place. my OEM switch had a locator on the top side and 2 on the bottom... in the end, it works great as a replacement assuming you don't need the 2 extra pins.
Recommended Products
$26.23
$ 13 .99 $13.99