Shopping Cart

Your cart is empty.

Your cart is empty.

Replacement Return Header Fit for Raypak 206A - 407A with Seal and Flange Nut Kit for Raypak Pool Heaters 206A 266A 336A 406A 407A, Replace for 015095F

5.0 Write Review
Free shipping on orders over $29.99

$98.99

$ 46 .99 $46.99

In Stock
  • 【Wide Application】Widely fit for all RP2100 heaters models with polymer headers. Compatible with Raypak 206A, 207A, 266A, 267A, 336A, 337A, 406A, and 407A pool heaters. Replacement Part Number: 015095F.
  • 【Direct replacement】Directly replaces the original return header to fix the leak and get your pool heater back in operation. Comes with instructions for easy installation. Please make sure water, gas & power have been turned off before installation.
  • 【Easy Installation】Only takes you a few minutes to install. Simply remove the original return header, assemble the drain plug O-Ring, drain plug, and header O-Ring onto the new return header, install the new header and tighten the twelve 7/16" hex head nuts to secure the header. Note: Bolts must be tightened in the correct order and to the right torque specs.
  • 【Package Contents】This kit Includes everything needed to install the return header: 1x Polymer Return Header, 1x Header O-Ring, 1x Drain Plug, 1x Drain Plug O-Ring, and 12x Flange Nut.
  • 【Satisfaction Guarantee】If you're not satisfied with the product, simply return it for a refund in 30 days. We support 30-day refund for return and 12-month warranty.


Product Description

Deargooday
Deargooday
Deargooday

Easy Installation

Deargooday

STEP 1

Remove the access panel.

Deargooday

STEP 2

Loosen the twelve 7/16” hex head nuts and remove the original return header.

Deargooday

STEP 3

Clean the tube sheet of any debris, sealant, and any remains of the old gasket.

Deargooday

STEP 4

Install the drain plug to return header.

Deargooday

STEP 5

Lubricate the perimeter gasket with any silicone based lubricant and place the perimeter gasket in the groove of the header.

Deargooday

STEP 6

Install the replacement header and the twelve 7/16” hex head nuts. (Follow the torque pattern when tightening the nuts)