Your cart is empty.
Your cart is empty.Is your vanity ironing board cover getting a little worn? No worries, we have a replacement cover that was designed specifically to replace the Rev-A-Shelf® VIB-20CR ironing board covers. So You can keep it looking like new.
MCK
Reviewed in the United States on May 28, 2024
A little difficult to install, but if it lasts as long as the original, I don't need to worry about it any time soon.
VIP - a Customer!
Reviewed in the United States on November 4, 2019
Thank heavens our cabinet maker installed this beast. Had to add a board to side of drawer even though tho the drawer was within the specs.And the best news? My husband loves it.
larry pelka
Reviewed in the United States on April 6, 2018
The very best replacement for a smaller ironing board. Excellent ways to tighten
M. Ehemann
Reviewed in the United States on April 19, 2018
This was too long for my rev a shelf board, but I just pulled the excess to the back and it works just fine! Great replacement.
Patricia Huntsman
Reviewed in the United States on September 30, 2016
The cover is too short and will not stay on. I am only able to use the padding and old original cover.
G. H.
Reviewed in the United States on June 26, 2015
Fits well.
DKS
Reviewed in the United States on March 26, 2013
We purchased a home that had a pull out small ironing board in the closet that fit in a drawer...but it had no cover. This cover fits perfectly...the only reason I didn't give it 5 stars is there are no instructions on how to use the little "buttons" that I presume help hold the cover in place, but I haven't been able to get them to work. Since the ironing board folds, the cover comes off every time I fold it up to put away...I purchased some ironing board cover elastics to help hold in place. It would be better if the cover came with those.
L. Martin
Reviewed in the United States on December 19, 2013
Our built-in ironing board specifically lists Rev-A-Shelf as the appropriate brand for replacement covers. However, while this cover may technically "fit" our built-in ironing board, it doesn't stay on no matter what we do. There were no instructions so we were on our own. We used the pins provided to try to hold the cover in place, but the part over the end (where most ironing is done) keeps flopping off and has rendered the entire board useless. We have now put up a traditional ironing board for any actual ironing, which is very annoying because we paid for the built-in board as part of an expensive renovation of our laundry room. My advice if you have a built-in board: don't take the original cover off no matter how burned or cruddy it looks because replacing it will be impossible!
Recommended Products
