CHRISTIAN GARIEPY
Reviewed in Canada on June 29, 2024
Recu à temps
keith sommerville
Reviewed in Canada on April 12, 2024
Great value
Chuy
Reviewed in the United States on July 24, 2023
Good solid product
Carter
Reviewed in Canada on June 26, 2023
Good quality, heavy brass. Smooth adjustments.
Jose manuel cruz Rodríguez
Reviewed in Canada on October 16, 2023
Is work very nice
David W.
Reviewed in Canada on March 15, 2022
I purchased this regulator to charge the air suspension system in my 2016 Ram 1500 and I was not expecting much given the great price.This item is perfect for my needs. For the price you can't go wrong!
L. A. Jones
Reviewed in the United States on July 28, 2021
I did a DIY A/C replacement with Mr. Cool. I didn't get the pre-charged lines so I used this set. I used it to pressure test the system over a few days. It worked great. Not cheep for one use, but way better than paying the 5K for someone to install my system.
Tom Pollard
Reviewed in the United States on April 24, 2021
Great value
Customer
Reviewed in the United States on May 25, 2020
Works well, only issue was the part that goes into the nitrogen tank had a little niche/ damage on it. Like a deep scratch. Didn't want to seal the first few tries, then I just tightened it a little more than usual and no loss.
PBP
Reviewed in the United States on August 4, 2019
Works as great as the more expensive one.. at half the cost.
Wes
Reviewed in the United States on May 24, 2019
I need to perform two 500 PSI nitrogen pressure tests. This regulator is pretty tough to turn up that far but it is capable of at least 500 PSI. I didn't try to get to 600. Overall, it was perfect for my application. The output gauge did match my HVAC gauge set pretty well. It was a great value for me.
Sci-Fi Fan
Reviewed in the United States on June 4, 2018
Seemed very accurate when paired with a precision manifold gauge A/C set.Only minor gripe is when testing at 400psi (mid scale on the regulator gauge) you really have to exert quite a bit of turning force on the "T" handle... I doubt it would actually crank up to 800 psi if ever needed.Solid brass quality!
Don Schmidt
Reviewed in the United States on December 22, 2018
Everything with the regulator works except the outlet pressure gauge. The needle is on the wrong side of the stop. I’m only using this set up to gas race shocks and have another regulator at the end of the fill line. Don’t see a way to contact the seller about the issue. Other than that the product works fine.