SamIam
Reviewed in the United States on September 15, 2024
Product did not come with necessary parts. Not only did it not come with both of the brackets necessary, the one bracket that was included was not the right one. It’s hard to tell in the picture but you have to drill out extra holes to make it fit. For what it cost, I am not impressed.
Cassi Cline
Reviewed in the United States on June 25, 2024
This piece fit very good and installation was not hard at all. I would say a good value for the money.
Liza
Reviewed in the United States on June 16, 2024
Installed it in my 2014 4runner fits perfectly and easy to install
Robert Ach
Reviewed in the United States on November 8, 2024
I bought this to replace one that was scratched recently. Note that the page states that it does not fit a 2019 4Runner, but it fits perfectly on mine.
Robert H. Schoon
Reviewed in the United States on August 26, 2023
Really good fit and finish. Looks totally factory on our 2011 4Runner. Replaced the factory (non-JBL) radio with a double DIN Kenwood. Brackets worked well. I was concerned about them being plastic but they work fine and maybe are even better as they allow a little bit of compliance so the new screen lined up really well with the opening in the new dash panel. Very happy for the price.
Ryan E.
Reviewed in the United States on December 15, 2022
Good deal for the money. Good fit & nice finish.
Ash N
Reviewed in Canada on June 9, 2021
For some reason it only uses two of the four screw holes at the bottom to hold the kit in place, but together with the many clips, the kit as a whole still holds very well at least with a lighter mechless unit. The one edge along the top of my kit was a bit rough, but aside from that the fit and finish was good, no gaps and blends in well with the dash. Still a lot more bearable than supporting Metra.
cds
Reviewed in the United States on December 29, 2018
Worked perfectly, there are a bit of "off cuts" when the part was cleaned up after molding. But at this price you can expect small imperfections. From the driver seat tho, it looks factory, even tricked my wife when installed. The fitment with the Pioneer 4200NEX unit is perfect, with no major gaps from any angle.My part came with no blemishes, and the finish matched the stock car perfectly.
Mrs.Kimberly
Reviewed in the United States on November 2, 2018
Fits perfect in my 2010 Toyota 4runner SR5. could've been the radio but it was a little bit of a pain to get in the radio is a 6.2 inch and there is no wiggle room so you cant go any bigger than the 6.2 inch. We did have to use the plastic brackets that came with the face instead of the original manufacturer metal brackets. Otherwise 5 stars cause it does fit and looks great!