Your cart is empty.
Your cart is empty.Drying plaster work, heating shrinking tubes and soldering sleeves onto cables – the HL 1620 s hot air gun makes light work of any job, with It’s weight of just 1.48 pounds and its optimized weight balance. Additionally, the built-in kickstand support provides stability and prevents tip over. With a 20 percent higher durability than its predecessor and equipped with a robust ceramic heating element, it offers two heat and fan settings (575 or 950˚f, 8 or 13 cfm). the 10.9 amp motor generates an output of 1,300 Watts. The HL 1620 s multi-purpose heat tool has an built-in overload protection to prevent overheating and complies with applicable UL and RoHS standards. Fits all 1.34 inch diameter industry standard nozzles.
Sandra Edwards
Reviewed in the United States on February 1, 2025
I purchased this heat gun for use solely in heatwrapping and find it to be great! For a big job or lots of items to shrink-wrap, it's great. I actually purchased it again when I needed a heat gun at another location.
festes
Reviewed in the United States on September 19, 2024
ok
Danel
Reviewed in the United States on May 9, 2024
Have been using it about 3 months for window tinting. Doesn't blow strong and rattles. Feels pretty cheap, too. Buy you a porter cable.
Eduardo E. Guerrero
Reviewed in the United States on February 6, 2024
this is my fourth Steinel heat gun, great product!!!!
Ron
Reviewed in Canada on December 4, 2023
Product work as per description.
Dave Smith
Reviewed in the United States on November 18, 2023
Works great for shrink tube, so far, so good
Nick B.
Reviewed in the United States on March 7, 2022
Disclaimer. We use these to tint cars in a shop.The gun is not hot enough it has good air flow though. It is very large in your hand, the switch feels cheap, and the overall feel is not one of quality. The power cord is better than a Wagner or like unit. Overall it’s a good performing heat gun for around the house but for shop use I would not purchase another.
Recommended Products
