Shopping Cart

Your cart is empty.

Your cart is empty.

TEMCo THA039 2-1/2' Conduit Punch and Die For METRIC Hydraulic Knock Out Driver M20x1.5mm Thread

Free shipping on orders over $29.99

$29.99

$ 15 .99 $15.99

In Stock

About this item

  • Conduit Fitting Size: 2-1/2", Actual Hole Size: 3"
  • Required Punching Force: 13 US Tons
  • METRIC THREAD - Fits Draw Stud Size: M20x1.5mm (TEMCo THA010 and THA011). This DOES NOT fit TEMCo draw stud THA001 or THA100.
  • Punching Thickness Capacity: 1/8" (11 ga) Steel, 1/16" Stainless Steel
  • Made of Hardened Tool Steel with Black Oxide Finish. Punches Materials: Steel, Stainless Steel, Brass, Copper, Aluminum (soft alloys only, not for use with 7075 or other super alloys), Fiberglass, Plastic and more.


Our punch dies are sized to conduit sizes, not actual hole sizes. Electricians use these sizes because conduits are measured by the inner diameter of the tube, not their outer diameter. That means, for example, a 1" punch die will correctly punch for a 1" conduit tube (which has an actual hole size of roughly 1.33"). We've provided you with a handy table below that shows the actual hole size produced by our punch die/conduit sizes in this set.
This set includes a single punch and die set. Punch die sizes are equal to conduit tube sizes.


Beal simmons
Reviewed in the United States on August 30, 2023
I have both a milwaukee punch, and a Greenlee punch, the inside of the die is a hair too large for either stud and nearly messed up the thread on the stud, do not buy as a replacement.
Recommended Products

$33.96

$ 15 .99 $15.99

4.7
Select Option

$19.95

$ 9 .99 $9.99

4.5
Select Option

$17.52

$ 7 .99 $7.99

4.5
Select Option

$99.28

$ 47 .99 $47.99

4.3
Select Option

$58.86

$ 29 .99 $29.99

4.5
Select Option