Your cart is empty.
Your cart is empty.Steven Webb
Reviewed in the United States on September 1, 2024
I used this to mount a trolling motor to the swim deck of my 19 ft bow rider. The trolling motor is 89lbs of thrust with a 24V supply. It ain't small. This plate, along with upgraded mounting hardware, works really well. I did have to replace the plastic spacer blocks with wood as they couldn't handle the weight. That was to be expected. The main mounting plate has proven to be a beast. It holds a large motor, on a large boat (relatively speaking), with a large amount of thrust. It does all of this effortlessly. To date the sealant applied around the mount perimeter shows no sign of cracking or flex. Although this isn't really the application it was designed for, it handles it with zero issues. There are other products designed for my application. They also cost three times as much. I could not be happier with the end result.
Jonathan.
Reviewed in the United States on August 6, 2024
It is not meant for saltwater took it out once and it was already rusting also screws don't tighten the block to the frame had to buy differnt ones to fit it snug
Customer
Reviewed in the United States on December 13, 2024
Great service as well.
Steve M Smith
Reviewed in the United States on November 9, 2024
well built
kp
Reviewed in the United States on October 7, 2024
good product
Rich
Reviewed in the United States on October 5, 2024
holes lined up perfect to the holes in my kayak plenty enough spacers to get the motor past the stern
Zack M
Reviewed in the United States on September 18, 2023
Works great on my perception outlaw 12'. I had to use a small piece of wood underneath to level it to make it fit inside the kayak's cutout precisely but the item itself does great. I would recommend larger washers than what was given just to ensure the load/pull on the plastic is greater displaced but I was able to pick those up for 60 cents at the hardware store. Great product, use it for my trolling motor all the time.
Nakina
Reviewed in the United States on July 19, 2023
I'm not sure what kayaks this would fit. The dimensions are pretty big for a kayak.It won't fit my Jackson Yupik because the dimensions are way bigger than the recessed 4 hole mount area.There are holes that match up but the plate is at least an inch too wide all around to fit down in it.I am going to try a spacer made out of an old plastic cutting board which may be enough to raise this transom mount to deck level where it will fit.The plate is really heavy, probably way more than you would want on your kayak. Seems more appropriate for a larger boat.If you like the price and don't mind doing some custom fit work it may do the job for you.Also doesn't fit the mount area on a Jackson Mayfly, Coosa HD, Kilroy etc or really any kayak that has a recessed 4 screw pattern mount area.
Recommended Products