Your cart is empty.
Your cart is empty.Uniweld Type17-15 rosebud heating tip is capable of brazing 1/8" to 2 5/8" of copper. Tip elbow is copper, mixer and nut are brass. Overall length is 7". Has two O-Ring seals so tip nut only needs to be firmly hand tightened. Tip will fit Uniweld Part# 71 or Part# WH550 welding handle.
scott kibling
Reviewed in the United States on November 9, 2024
Very nice brazing tip for doing bigger pipe
Customer
Reviewed in the United States on October 20, 2023
As a after market / knock off victor heating head its perfect .especially because Victor doesn't make this size anymore .
Dog lover
Reviewed in the United States on April 15, 2023
Great, raising tip well worth the money
crazytekkie
Reviewed in the United States on August 4, 2021
Omg I can't believe ive been brazing all this time without this tip. Fits my generic ameriflame welding torch just fine and makes a huge difference heating surfaces. Brazing copper pipes larger than 1/4" is no longer a difficult task.
Prime Member
Reviewed in the United States on September 13, 2019
Works great with my Oxy/Mapp porta torch setup. It puts out some serious heat using a Victor J28 handle...one of my new favorites for my small torch setup. Haven't tried it on Propane and Acetylene yet, but will in near future - based on the way it works with Mapp, I think it will be fine with any fuel gas. The connector will not fit the middle sized 100FC handle - it's for the small Victor J series torches.
August
Reviewed in the United States on March 3, 2019
Makes brazing fast and efficient. Heat control is paramount with this tip, like someone else said, this thing makes whatever you point it at, HOT!
Tito
Reviewed in the United States on August 16, 2017
Very useful tip, heats up pipe almost evenly which will save you time brazing.
bluelight
Reviewed in the United States on May 30, 2017
9 small flames are better then 1 huge one. It keeps heat concentrated and wide spread. It makes pre-heating very quick and assist with brazing. According to the manufacturer specs the pressure is 10 psig Oxygen and 8 psig Acetylene/Fuel.
Recommended Products
