Your cart is empty.
Your cart is empty.Product Description
- This collet is used for CNC milling lathe tools and engraving machines.
- The collet must be placed into the collet chuck nut before inserting it into the collet chuck.
- Used with straight shank, tool holder, extension bar nut; used to hold drill, boring tool, carving tool, and reaming tool.
Blake
Reviewed in the United States on January 31, 2025
The media could not be loaded.
JC
Reviewed in the United States on January 25, 2025
They fit fine. I use them to hold my engraving bit. 1/32 ball mill. I can't tell you what the run out is, but they work perfectly fine for my need.
Gujustud
Reviewed in Canada on September 19, 2024
Purchased 3 sets of the 1/8" size collets and they don't fit in any of my holders (mix of good holders as well). Only purchased because I needed them overnight, but they were all useless.
Ben
Reviewed in the United States on May 27, 2024
I bought these just because they were the only collets available with overnight shipping. Unfortunately they're completely unusable with 0.004" of runout which is amazing that it's that little by the way the collet sits uneven in the tool holder. Both collets are completely useless. I was hoping that one of them would be close enough to use but they're both so far off that I can't even use them.
nic
Reviewed in the United States on March 28, 2023
Works as excepted so far, glad then came with the case so they don’t get lost in the drawer.
Clark
Reviewed in the United States on November 17, 2023
Ordered two separate sets and in both only one of the two collets would accept a 1/4 endmill
Recommended Products
$63.10
$ 30 .99 $30.99