Your cart is empty.
Your cart is empty.Product Description
Reset Temperature
Normally Closed: When the temperature falls to the reset temperature, the thermostat contact can be connected again. (If the reset temperature is not reached, the thermostat contact is also disconnected)
Normally Open: When the temperature falls to the reset temperature, the thermostat contact can be disconnected again. (If the reset temperature is not reached, the thermostat contact is also connected)
Please Note :
- During installation, the temperature switch should be completely close to the mounting surface of the tested appliance.
- Do not collapse or deform the plastic / metal shell during installation.
- For metal temperature controller, when using, do not remove the insulating sleeve to avoid electric leakage.Not suitable for working in water.
- Not suitable for air temperature sensing, only applies to contact sensing.
Jake from statefarm
Reviewed in the United States on August 24, 2024
worked for my application in controlling a small 6v 5a radiator fan for my rc car. it opens and close within a reasonable threshold consistently.
Jim
Reviewed in the United States on December 7, 2023
I got these to press in the space between fins on aluminum heat sink on the back of an MPPT solar charge controller. I am running it at its max so to help keep it cooler these thermostats, in parallel for backup, click on to run a cooling fan. They click on at close to 45C which is about 350 watts on the controller. The controller is rated at 550 watts so it is doing very well.
Robert Bruce
Reviewed in the United States on November 30, 2023
I had bought 2 of the 12volt power units (from China) and the units work very well with one exception the fan noise on these are horrible. Saw a YouTube post of how to fix the fan noise. With the switch you can run in inline with the fan, and then place the thermal sensor on the transistor heat sink, this will keep the fan off until a desired temperature is reached and then the fan will turn on. These are set at 45 C for on and 33 C for off. Under load the my 12volt power supply never reaches 45 C it never peaks above 33 C so why is the fan constantly on? Well here you go away to eliminate the fan noise but not loose cooling when required
jawdat A.
Reviewed in the United States on July 22, 2022
Item is like described will buy again.
Paul Oestreich
Reviewed in the United States on July 25, 2021
Used to control fans in RV
J. Heagy
Reviewed in the United States on February 28, 2021
Reacts fast on both rising and falling temps
KP
Reviewed in the United States on September 3, 2020
works fine with my PSU
EsQueue
Reviewed in the United States on October 15, 2019
Worked perfect for my project.
Recommended Products