Your cart is empty.
Your cart is empty.Vanquish Products Brass SLW 350 Wheel Hub, VPS01302
Jim D.
Reviewed in the United States on February 16, 2025
As Eliud J. stated in a previous review, these needed some definite alterations to work on my Vanquish H10 Optic. My problem was, I am running H-Tech 2.2" billet aluminum bead lock rims. The bore where the hubs have to seat is just a tad smaller than the brass hub's OD! I wanted to use them so...to my workshop!!! I took a piece of threaded rod almost the same size as the hub's inner bore, put two nuts on and tightened as a lock nut, a 3/8" washer, the two hubs, another washer & two more lock nuts, leaving enough space for the hubs to spin on the rod. I then added one of the stock AL hubs for scale and another washer and nut. I put a 160 grit carbide belt on my belt sander, clamped it in my industrial vice and started to gently spin the hubs to take off some brass, while watching the AL hub to make sure I didn't take too much. Damned if it didn't work... who needs a lathe! Then, I go to bole them on and H-Tech uses 2.5mm bolts and Vanquish uses 4mm... aaaaaagh! I actually had to re-drill 6 bolt holes in each of the (relatively expensive) front wheels... fortunately, I had bolts! About 3 hours and a 30 minute job was completed! (better than sending them back)
Eliud J.
Reviewed in the United States on October 9, 2022
Just as advertised. For my application I needed to do a little work on it but my application was not typical. Iām sure I can used this in typical work without issues.
Recommended Products
