Your cart is empty.
Your cart is empty.Andrew C
Reviewed in the United States on March 18, 2025
These were exactly what I needed for my project. It was easy to crimp terminals on the ends of the wire and the cover snaps on firmly even with a fuse installed. It was a little tight to push in a fuse (I'm not sure if the legs on the fuse were soft or the terminal receptacles were just too tight), but being careful worked and all is good.
Eric Soliz
Reviewed in the United States on January 27, 2025
Good quality, the only issue is that the fuses are so hard to get in that I bent 3 of them before finally getting one in the holder.
DanangDoc
Reviewed in the United States on January 1, 2025
Very tight (ie. thick) sockets, tin plate over copper, ~ 8" leads, TW? insulation over very fine stranded tin plated copper - very flexible and resistant to flex fatigue failure. Very tight fitting cover likely very water resistant.
Customer
Reviewed in Canada on September 23, 2024
Good value
Shopper
Reviewed in Canada on September 1, 2024
Good
Francois B.
Reviewed in Canada on August 10, 2024
The fuse itself is fine but this seller advertises 8 awg, which is what i needed and bought but that’s not what I receivedI stripped the wire to crimp it to a terminal, it looked a little smaller than expected and unfortunately its 10 awg wire contrary to what is advertisedThe maxi fuses are hard to slide in and retrieve as its a tight fit, but thats fine thats what you want
Gunship
Reviewed in Canada on July 4, 2024
Standard quality and not awg10 cable like the item description. Photo of the product not the same as i received
George
Reviewed in the United States on July 18, 2024
Size correct, quality part.
Bryan
Reviewed in the United States on June 23, 2024
Some dislike how snug the fuse is to push in. I personally prefer the tight fit to prevent a loose connection and ensure the current is going through the fuse element and not heating up at the fuse contacts. They are a little tough to insert the fuse but not impossible
Lowell t.
Reviewed in Canada on June 17, 2024
I used it to power a scale head
timaz
Reviewed in the United States on November 24, 2024
Very poor design as the housing holding the fuse melts without blowing the fuse. I have gone to another method because I have had two of these melt with less then 50 amps and the fuse didn't pop.
Altimatic
Reviewed in the United States on December 15, 2023
using them with 80amp maxi fuses and theyre working great
Reloader57
Reviewed in the United States on November 4, 2023
Didn’t work for me, my mistake. But definitely excellent quality.
Recommended Products