Your cart is empty.
Your cart is empty. Model
For Suzuki GSF600 Bandit 2000-2004
For Suzuki GSF650 Bandit 2005-2006
For Suzuki GSF1200 Bandit 2001-2006
For Suzuki XF650 Freezing 1997-2004
For Suzuki VL800 intruder Volusia 2001-2004
For Suzuki SV650 1999-2002
For Suzuki GSX1300R Hayabusa 1999-2007
For Suzuki GSX750F Katana 1998-2006
For Suzuki GSX600F Katana 1998-2006
For Suzuki GSX-R750 1996-2019
For Suzuki GSX-R600 1997-2019 K1 K2 K3
For Suzuki GSR600 ALL YEARS
For Suzuki GSR750 2011-2017
For Suzuki DL650 Vstrom 2012-2019
For Suzuki DL650XT Vstrom 1999-2002
For Suzuki TL1000 R/S 1998-2003
For Suzuki VL1500 intruder 2013-2017
For Suzuki VZR1800 2011-2019
For Suzuki intruder c1500 2013-2017
For Suzuki Boulevard c90 2013-2019
For Suzuki GSX250R 2018-2019
For Suzuki GSX1000F Katana 2019
For Suzuki GSX1400 2001-2009
For Suzuki GSXR1000 2001-2016
For Suzuki GSXS750 2015-2019
For Suzuki GSXS750Z 2018-2019
For Suzuki GSXS1000 /F/A/FA 2015-2019
For Suzuki GSXS1000Z 2018-2019
▶Install
First Locate the Speed Sensor connector:
1.The Speed Sensor is usually mounted on the front sprocket cover, and the 3-pole black speed sensor coupler (as shown in the figure) is situated 20-40 cm (8"-16") away from sensor.
2.The connector is accessible by raising the fuel tank, removing the seat or a side fairing(as shown in the figure).
▶Confirmation:
1. Separate the Speed Sensor connector (you might need to use a small flathead screwdriver to get the connector apart).
2. After separating the Speed Sensor connector, plug in both the male and female 3-pole GFYSHIP harness connectors. Make sure the connectors are fully seated.
3. Find the wire that comes from the Signal generator (Pickup coil / CKP sensor).
4. Connect the Green wire to this wire, using the Red wire tap connector supplied.(The green wire is connected to the crankshaft sensor signal line)
$44.33
$ 19 .99 $19.99