Shopping Cart

Your cart is empty.

Your cart is empty.

WeatherTech Custom BumperTopper for BMW X3 - Rear Bumper Protector (BP0001) Black

Free shipping on orders over $29.99

$61.95

$ 29 .99 $29.99

In Stock

About this item

  • Fits select 2018-2021 BMW X3 30i, 2020-2021 BMW X3 30e, 2018-2021 BMW X3 M40i, 2020-2021 BMW X3 M Models. Please confirm fitment to your year, make, and model in Amazon Garage prior to purchase.
  • Coverage: Rear Bumper, Color: Black
  • Safeguard your rear bumper from scratches, paint chipping, and everyday wear and tear with the WeatherTech BumperTopper. Made from an impact-resistant hard plastic, it stands up to damage. When it’s time to trade your vehicle in, BumperTopper also helps cover small scuffs and blemishes to protect resale value.
  • BumperTopper attaches directly to your bumper’s surface with Very High Bond adhesive strips. A Center Indication Mark makes installation quick, easy and accurate. This rear bumper cover hugs the profile of your vehicle’s bumper for custom-fit protection. BumperTopper is thin enough (3mm) to allow complete closure of your trunk or hatchback, yet tough enough to protect your vehicle.
  • Made in USA!



Product Description

Hero Shot

(BumpStep Sold Separately)

WeatherTech BumperTopper

Shield your rear bumper from damage.

Rear Bumper Protector


Safeguard your rear bumper from scratches, paint chipping, and everyday wear and tear with the WeatherTech BumperTopper. Made from an impact-resistant hard plastic, it stands up to damage. When it’s time to trade your vehicle in, BumperTopper also helps cover small scuffs and blemishes to protect value.

The video showcases the product in use.The video guides you through product setup.The video compares multiple products.The video shows the product being unpacked.
  • Waiting an hour or two will provide adequate adhesion for driving. Full adhesion takes up to 72 hours.

  • Installation is recommended in temperatures 60 degrees or above, or inside a heated garage.

  • The BumperTopper measures 3mm thick.

  • Yes. When properly installed, you can safely enter a car wash.


Nate B.
Reviewed in the United States on August 24, 2024
Unfortunately life got in the way did I didn't try to install this until after the return period but it didn't fit, Not even close. The bend is too big and there is a huge gap between the protector and the bumper.
CJH
Reviewed in the United States on July 10, 2024
Tried the paint protection film, too many bubbles (my fault no doubt). This piece fits perfectly, straightforward installation.Gives a “rugged” look to the bumper. Covers the edge, where most of the damage would occur. Very pleased.
ga golfer
Reviewed in the United States on June 11, 2024
I first bought a cheaper brand and didn't like it. I switched to WeatherTech and I'm very satisfied. It looks like it was factory.
DT
Reviewed in the United States on May 7, 2024
Fits our 2021 BMW X3 M40i
RICK J.
Reviewed in the United States on May 14, 2024
Very good quality product. I’m going to have to remove and install again due to my error not the product’s. Be careful that you match the angle of the trim piece with that of the bumper. Mine is off just a little so the overhang isn’t quite flush. Again, this is my error and not the product’s.
gary sebach
Reviewed in the United States on December 31, 2024
This was easy to install and fits perfectly. It is good quality for a reasonable price.
Stephan A
Reviewed in the United States on October 2, 2023
I'm usually a fan of weathertech products, but not this one. The hard plastic is mediocre quality -- it is not very black (more of a gray) and it is not very consistent either with swirly patterns in it. Finally, the adhesion isn't great -- one side of my cover came up apparently because it warped from the heat. I will likely end up trashing it entirely. Not recommended.
Recommended Products

$79.55

$ 32 .99 $32.99

4.3
Select Option