Your cart is empty.
Your cart is empty.Weiler's brushes are permanently mounted on 1/4 inches steel stems, providing quick installation on chuck or collet. High RPM ratings provide faster finishing for the lowest cost-per-piece brushed.
Customer
Reviewed in the United States on May 2, 2022
Use on my die grinder and it holds up well at high speeds. Much better harbor freight obviously but purchased at marked down price that compared to the cheap store, so I bought two. They get a lot of use, but I'm sure they'll last. Would recommend.
Brennan Anderson
Reviewed in the United States on September 26, 2021
They last a long time. I’ve used 1 for over 10 brake jobs so far and it’s still going strong
STi555
Reviewed in the United States on January 11, 2018
Same as the snap-on man at half the price.
Joel Vasile
Reviewed in the United States on June 23, 2017
Works well
Davao David
Reviewed in the United States on April 22, 2016
Wears-out evenly when used bidirectionally in a cordless/reversible drill and when the wires get short it can be use to remove stubborn material.
Edward H
Reviewed in the United States on June 15, 2014
Brush was slightly softer then I expected but it works well for cleaning battery cable ends. The brushes I have been using were for removing water pump and head gaskets , This one is just lighter and I found other uses for it. It seems to be holding up to the speed that my die grinder puts out and the wires are staying in place. I'll get another one after this one gives out. The price is right compared to the tool trucks that I have been buying from.
Recommended Products