Your cart is empty.
Your cart is empty.Brian Montanaro
Reviewed in the United States on February 28, 2025
Work perfect!!
Customer
Reviewed in the United States on February 12, 2025
Nice roller wheel, good bearings and easy to swap out.
VFRJOHN
Reviewed in the United States on August 4, 2024
Installed with no problems. Seem to be very well made, substantially more quiet compared to metal originals.
Adler
Reviewed in Canada on June 11, 2024
One of the rollers arrived with the dust shield installed backwards so that it could spin freely.There are only 8 balls in these bearings despite the description saying they have 13. These are the cheapest bearings you can get.
Customer
Reviewed in the United States on October 15, 2024
Great product.
Dana C.
Reviewed in Canada on October 11, 2024
They work well. I wouldn't say it's much quieter than before but they are pretty good.
L. YUEN
Reviewed in Canada on January 6, 2024
didnt quite fit in my brackets. didnt notice any great noise reduction
Philip YYC
Reviewed in Canada on September 3, 2023
Was quoted over $300 with installation to replace the roller bearings. Thought i’d try to do it myself.Works good and for the price. You can’t beat it
Customer
Reviewed in Canada on July 30, 2023
This product reduced the noise of my garage door considerably. The old steel rollers were quite noisy. Check out videos on YouTube for easy installation tips.
Iron Head
Reviewed in the United States on March 27, 2023
The rollers slide right in and are smooth and quiet.My door was installed in 1982 and I should have bought these rollers years ago.Easey Peasy!
Lotza Certs
Reviewed in the United States on November 1, 2022
My research indicated that more ball bearings resulted in quieter operation. These 13 bearing wheels installed easily and resulted in a smoother garage door experience.
Marc G.
Reviewed in the United States on April 20, 2021
Pretty easy to install the first four down from the top of the door, but you must be very careful with the bottom two as they are under a load from the springs, I have the springs along the rails and I was able to remove the cables when the door was fully open and the cables were not under a lot of pressure. Very good wheels and the noise went down a lot.
blake pretti
Reviewed in the United States on November 16, 2020
I learned the hard way to losing top bolt in the just a little bit bracket holding roller and take the other 2 or 3 bolts out. Pull old roller out and put new one in. Don't do what I did , I took all the bolts out of bottom bracket and it took off like a rocket. If you leave 1 bolt in that should not happen. I still had a squeak left after installing rollers when door was almost fully open . With the door all the way up I adjusted top roller and that fixed problem.
Recommended Products