Your cart is empty.
Your cart is empty.Product Description
Item: Belt 1/2-inches x 10feet, Type A
Material: Polyester/Polyurethane Composite
Feature:
Save Time - No wasted time dismantling drive components.
Easy Installation - Belts are made to the required length by hand and roll on to the drive, no tools required.
Longer Belt Life - Extremely high strength and low elongation under load results in increased belt longevity and durability
Reduce vibration - Smooth running with less vibration than solid belts.
High Performance Composite V-Belts 1/2-Inch x 10 Feet A Type Perfect for Lathes, Drill Press, Table Saws and Other Woodworking Tools
Our Link belting is a perfect candidate for drives that have no take-up adjustment capability or for use as an emergency replacement belt.
Suitable for any length, No tools required, easy installation in minutes without dismantling drive system components.so that the production line stop time is almost zero.
Mack Benson
Reviewed in the United States on February 14, 2025
This linkable belt works better than I could have imagine Easy to use.
Susan D.
Reviewed in the United States on January 11, 2025
Works as expected
bdhende
Reviewed in the United States on August 10, 2024
Completely changed the way my bandsaw and metal lathe work vibration free
Peg leg
Reviewed in the United States on March 8, 2024
Haven't turned on my lathe yet but it's a lot easier to install these on my Logan lathe for the two spindle belts then using endless belts. Had a chance to run my lathe with them and they seem to work good no slipping or anything I can tell and it even seems like I could go one link shorter and it would perform better I just can't get it over the double pulley or I would try. But as long as there durability is good I would definitely purchase them again
I like BEER
Reviewed in the United States on November 27, 2024
3 stars for ease of use / 0 stars for noiseIf your motor is running somewhere that is isolated then the noise probably wont be an issue.I'm using the belt on a large tumbler system and the sound of the belt can actually be heard over the 1/3 HP tumbler . It would be ok for emergency use but I went back to a Gates rubber v- belt and it dropped the db by 18 which is significant
Markcusp
Reviewed in the United States on November 2, 2024
These belts use a thermoplastic material versus the urethane used on the ones I purchased decades ago. Tried them on my noisy startup compressor, this was a mistake. No good on high torque applications. These belts literally started to melt after running just a few seconds when I was checking the belt tension. When I did get the tension right it still was slow to grab the pulley and started to melt again!! I am talking droplets of plastic that had to be peeled off the belt. Also the reinforcing fibers used is laughable compared to the originals from years back.Look for the original urethane type and forget these. Will be looking for a refund.
Jacob Stecher
Reviewed in the United States on December 25, 2022
If you never used this before you are in for a treat more torque more versatility just a great product.
Michael Boggs
Reviewed in the United States on October 30, 2021
These belts are expensive, but they are the best I've ever used. They are infinitely adjustable, extremely durable, flexible, quiet, and cut most of the vibration found in most other belts. They are well worth the price!
Recommended Products