Your cart is empty.
Your cart is empty. 2' length of 1-3/8" OD Stainless Steel Welded Tubing with a 16 Gauge (0.065") wall that is dual certified 304/304L and A249/A269. This product has been laser welded using a high-energy and high-density beam for a precise, narrow, and deep penetrating weld for excellent corrosion resistance. Our 304L stainless tubing is well suited for automotive exhaust, general service, cannery and winery service. Features a mill finished inner diameter (ID) and bright annealed outside diameter (OD).
This tubing undergoes a rigorous quality inspection, including destructive and non-destructive examination, at the mill prior to shipment. This 9 point quality inspection examines:
- Strength - Tensile, Burst
- Hardness - Rockwell, Micro
- Soundness - Eddy Current, Ultrasonic, X-Ray
- Leak & Strength - Hydrostatic
- Leak - Air Under Water, Pressure Decay
- Bend Testing - Reverse Bending, Flattening, Reverse Flattening, Flange
- Dimensional - OD, Wall, Straightness
- Metallurgical - Grain Size, Sensitization, Corrosion, Phase Balance/Intermetallic, Metallographic
Please allow for a cut tolerance of +/- 1/8" on all lengths under 20'. Call regarding any bulk orders greater than 100'.
Tim Beaubien
Reviewed in the United States on February 27, 2025
Needed this for a custom exhaust system. Nice material and a very nice finish. Easy to weld.
Able
Reviewed in the United States on February 17, 2025
Tube I received was sized as spec'd. Clean mill finished tubing. I used it as an exhaust pipe end cover over a mild steel exhaust pipe. I buffed up the tube's outer surface to give the exhaust pipe a dressier look.
dave
Reviewed in the United States on February 16, 2022
The product was reliably shipped and well packaged. The quality of the stainless was accurate and seamless
WADE O WINBLAD
Reviewed in the United States on February 1, 2022
Happy
C Dawg
Reviewed in the United States on November 20, 2020
This was exactly what I needed and arrived quicker than my local supplier could get it. Do note, this is not polished. It's a mill finish but not rough, it will polish well if you need. 16ga, 1 3/8" OD.
mark cates
Reviewed in the United States on November 9, 2019
I used the pipe for an inner sleeve on a patio table umbrella after three original pipe broke in strong winds. Worked great
Tim
Reviewed in the United States on September 14, 2018
$30 FOR 3 INCHES!!!
Lloyd Bjorndalen
Reviewed in the United States on November 14, 2017
Good product
Recommended Products
$7.24
$ 3 .99 $3.99