Your cart is empty.
Your cart is empty.25 pack of 1/4 inch flared white washers. These washers are perfect when fitting a swivel nut into MFL tailpieces. They are used for metal to metal (MFL to FFL 1/4") connections. If you have a CMB Disconnect with MFL you would not need these because there is already on built in. Protects against air loss and leaks by preventing metal to metal contact.
Preet
Reviewed in the United States on May 8, 2024
This was the right product for a co2 tank.
i am a cardboard box with a kitten inside of me
Reviewed in the United States on September 16, 2023
Smooth flare washers that seal well and get the job done for my kegerator setup.
Steven Gurnick
Reviewed in the United States on July 8, 2022
Excellent.
Wendy Freeman
Reviewed in the United States on November 1, 2021
I'm using these to seal lines that are troublesome to seal, high pressure refrigerant lines. I hope they work. Much cheaper than the fancy blue ones from the hvac supplier. Sometimes the flare is scratched and today's r410a is a high pressure refrigerant that will leak past a scratch.wish me luck!
JC
Reviewed in the United States on October 9, 2021
It helped stop small gas leaks.
Knowcigar
Reviewed in the United States on July 19, 2020
Quality washers. Just what I needed for my kegging system. Great price, quick shipping. Thanks
Homer
Reviewed in the United States on May 19, 2020
I needed more of these for new mfl connectors i bought but they had them built in. These were still quality washers and they came quick and were good for the price
Karen Lemermeier
Reviewed in the United States on December 31, 2019
Ordered 2 packs of 25 to change out all connections on home made draft system. All parts worked well, not more CO2 leaks. Price was significantly lower then elsewhere, good buy.
Recommended Products
