Your cart is empty.
Your cart is empty.Plug the unsightly open hitch receiver hole on your 2" Class III and Class IV Trailer Hitch. This will fit hitch receivers that have a 2" x 2" inside dimension. Install in seconds. Just push into hitch receiver hole.
Amozonian
Reviewed in the United States on February 2, 2025
i purchased this, to plug the opposite end of the hitch, after purchasing a fancier one for the visible end. it does the job. seals it off nice.
Hoffstepper
Reviewed in Canada on August 5, 2024
Fits in really tight, no worries of it EVER falling out.
magenm11
Reviewed in the United States on August 3, 2024
No issues, hasn’t fallen out
Josef Glowacki
Reviewed in Australia on May 14, 2024
As advertised product perfect fit.
Jim M
Reviewed in the United States on April 4, 2024
Quick shipping, no complaints
Yodagirl
Reviewed in the United States on July 15, 2019
Very snug fit so no worries about them falling out and vanishing, and also why I didn't rate the ease of removing. They need a screw driver to pop them out-you wouldn't want them any other way. Great price too.
jason
Reviewed in the United States on February 9, 2019
Doesn’t overlap the thickness of the metal and therefore doesn’t fully cover any discolored or scratched paint. Would get 5 stars if it were bigger
Jeremy Pomroy
Reviewed in Canada on January 9, 2018
It fits very tight, I had to hammer it in with my fist. You would definitely need something to pry it out with if you tried to remove it. But ill probably never use the hitch anyway.
Wayne Claydon
Reviewed in Canada on November 14, 2017
Fits perfectly
Customer
Reviewed in the United States on January 7, 2016
Fits great in my trailer hitch and looks great. The cover is a little difficult to get off the hitch, usually a small flat head screwdriver works to pry it off. I would definitely purchase again.
Maddy
Reviewed in the United States on April 10, 2016
Nice basic plug for the receiver. I don't use it a lot and this makes the hitch not so ugly. It does not have a large lip, so it does not cover the outer edge of the hitch surrounding the square hole. This might be a problem when it needs to come out, it did go in pretty snug.
Philip H. Ness
Reviewed in the United States on September 27, 2015
Since I don't normally use a hitch this is the perfect solution to plug the receiver hole and make the back of the truck look better. It can also prevent damage if I back into a car because it would prevent the end of metal receiver from touching anything.
Recommended Products
