Your cart is empty.
Your cart is empty.Product Description
How to Install?
Step 1: Compare screen sizes to make sure they are the same size. (Note: Face the side labeled "1" toward the laptop screen. Apply the positioning sticker to the same end as the "1" label)
Step 2: Use cleaning cloth to remove dust and stains.
Step 3: Use dust removal stickers to clean up fine dust to ensure that the screen is free of dust.(Note: Clean the screen, because dust can easily cause air bubbles!)
Step 4: Fixed "1"Tear off 4-6 cm from the bonding surface, align it with the edge of the screen and attach it.
Step 5: Tear off "1" the bonding surface on one side so that you can push it forward use a card.
Step 6: After pasting, Use card squeeze out the air bubbles, uncover "2" the outer mask, and finish.
Elle
Reviewed in the United States on March 29, 2025
Product and application method are horribly flawed. Demonstration video is highly misleading to look simple. Good luck getting the edges aligned properly the first time because after that you will have inevitable defective results. You will NOT be able to stop all dust from getting under the plastic during application, which results in bubbles. This is PLASTIC and is not perfectly flat and rigid like glass. Corners do not reliably stick down. Does it stop glare? Yes, but it also leaves your screen looking like it has defects.
Adriana Aguaguina
Reviewed in the United States on February 24, 2025
One of the laptops has a mouse pad fault
Caitlin
Reviewed in the United States on November 29, 2023
I have only used one of the protectors provided. I have a newer my dell laptop. It fits perfect and was very easy to apply. I have some bubbles because I had to remove it and clean the protector and reapply twice. I kept getting tiny dirt prices on it. I'm not the best at applying these things. I had an easier time with this one than those on my phone. It is very thin, no where as tough as those on the phone. If it were thicker, it would probably affect tough screen. My touch screen sensitivity seems to be pretty much the same. I think I maybe had to adjust to tapping a hair harder but I don't have any issues now. Except the con which is a big one is that the one I have on my computer (remember I only tried one so far) doesn't stick on the top left corner. It lacked adhesive on that corner. It is about a 1/2 inch by 2 1/2 inch area. So very small and not an area the touch is used in often at all. I can't use the touch screen in that area at all, and it looks like a large bubble of air. It doesn't bother me but clearly is a big con with this item. If that weren't there, I'd have no complaints
Recommended Products