Your cart is empty.
Your cart is empty.Product Description
2Pcs For Polaris RZR XP 1000 14-up Front or Rear Wheel Bearing (44x72x33) Fits Polaris RZR 570 800 900 Ranger 570 900 1000 Replaces Polaris Part # 3514699
- Replaces Polaris Part # 3514627, 3514699, 3514924, 3514822, 3515090
- Size: Sealed Ball Bearing 44mm x 72mm x 33mm
- Pack of 2 Front or Rear Wheel Bearings
- For Polaris RZR XP 1000 RZR 570 800 900 Ranger 570 800 900 1000 Sportsman 550 850 1000 Scrambler 850 1000 (See below for Fitment references）
User
Reviewed in Canada on September 18, 2024
Didn't last as well as oem
STL Zombie Hunter
Reviewed in the United States on June 6, 2023
After taking them to a machine shop to get pressed in, I was putting my Polaris Ranger 900 wheel hub back on and the outer bearing race kept falling off.
Chris B
Reviewed in Canada on August 18, 2022
Ordered these bearings for my 2012 Polaris Sportsman 550 which the ad says they fit. Installed them and they were too loose in the carriers. They slid right in and didn’t need to be pressed. They were no better than the bearings I took out. Had to waste my time replacing them again. Amazon did give me a full refund and didn’t request I return them.
Interceptor
Reviewed in the United States on July 7, 2022
Bearings were properly installed and torqued, they have so much play they are unusable. I bought the same brand for the rear and they were OK, but these front bearings have some sort of manufacturing defect.
john medynski
Reviewed in Canada on April 24, 2022
should have fit according to chart but inner diameter was wrong
Jj
Reviewed in Canada on April 16, 2022
They fit
Erin
Reviewed in Canada on June 11, 2021
Purchased to replace on 2018 Polaris Sportsman 1000 XP and they do not fit.They are to small as you can install without hammering them in. Push in with fingers is not a good sign as they are supposed to be tight. To loose and will cause differential issues down the road.Do not purchase for your Polaris Sportsman.
Airy Kay
Reviewed in the United States on April 1, 2021
These are poor quality bearings. The outside diameter is .003” smaller than the OEM bearing making the press fit too loose in the hub.
Rv'ing
Reviewed in the United States on September 9, 2020
put on my 800 rzr, was looser than my wore out bearing. Very poor workmanship, very loose, my tire/wheel assy moved up/down and sideways worse than old bearing. Tolerences were way off. bought a brg from polaris and that was a very good fit and no slop in tire/wheel movement. If I could give it a zero star I would. Don't waste your money.
Wayne B.
Reviewed in the United States on August 20, 2020
These bearings are junk I got one ride before the were falling apart. Don't buy these
Recommended Products
$34.95
$ 17 .99 $17.99
$29.99
$ 14 .99 $14.99