Your cart is empty.
Your cart is empty.Made of plastic, thanks to the high-quality workmanship, the set will be a long-term companion, easy to clean and works well
Bruce Smith
Reviewed in the United States on February 26, 2025
Great dual purpose tire chuck. My newest bike has presta valves. Instead of having to buy a new pump I simply replaced the chuck on my Harbor Freight bike pump. I was a direct fit. I used the second chuck to replace the broken chuck on a Ryobi 18V air pump. The OD of the Ryobi hose was a tad fat. I drilled the hole in the collar and shaved down the outside of the hose a bit. Works good. One note. the chick will leak air out of the opening not being used until you lock down the lever. So you have to be quick putting it on. Taking it off is a non issue since it just pops off when you release it.
Elinor L. George
Reviewed in the United States on August 16, 2024
Overall a nice unit that functioned properly. My original unit had a 3/8 hole in the nut and the hose was 3/8. The new unit has a 11/32 hole which was too tight for the hose but was easily enlarged by turning a 3/8 in drill bit by hand. Plastic seemed tough and not brittle.
Duane
Reviewed in the United States on August 12, 2024
as advertised , easy to use and speedy.
sandra craven
Reviewed in the United States on March 9, 2024
Much cheaper looking than original, but they work good so far. When original broke it was nice to find an inexpensive replacement to get it working again
crazyredj
Reviewed in the United States on February 2, 2024
I got this to work but had to rig a fit with a zip tie because the screw on cap wouldn't fit over the hose. It must be made for super thin-walled hoses. Still, I got it to work. Just that my pump looks comically Jerry rigged.
PQuincy
Reviewed in the United States on July 9, 2023
Looks like it will work fine, but it certainly does not fit all pumps with "standard" hoses, since I have two pumps these would not fit. My hose is 9mm or 3/8" (measured with tape), but many pumps use smaller hose, apparently.
daniel m
Reviewed in the United States on December 29, 2023
Purchased this to replace the original schrader pump head on my ryobi portable inflator to use on my bikes with presta valves. Works great. We'll see how it last long term but I don't see why it would develop any issues. This is great piece of kit for topping up your tires before a ride or for fine tuning tire pressures at CX and MTB races. Easy on easy off with no fuss.
D. B.
Reviewed in the United States on November 12, 2023
Does not fit a standard 3/8” hose. Check your hose prior to purchasing.I honestly can’t remark on the quality of the product because it didn’t fit any of my 3 pumps.
Recommended Products
