Your cart is empty.
Your cart is empty.
Replace Part Number:398453 398452 391305 439072 391937
Compatible Models:
For Johnson Evinrude 4hp, 1983-1993
For Johnson Evinrude 4.5hp, 1982-1984
For Johnson Evinrude 4.5hp, 1987
For Johnson Evinrude 5hp, 1984-1985
For Johnson Evinrude 6hp, 1984-1985
For Johnson Evinrude 7.5hp, 1982-1983
For Johnson Evinrude 8hp, 1984-1985
For Johnson Evinrude 9.9hp, 1974-1988
For Johnson Evinrude 14hp, 1968
For Johnson Evinrude 15hp, 1974-1988
Package included:1 x Carb Kit w/ Float
mbieser
Reviewed in the United States on August 25, 2024
Carb Gasket and manifold gasket were wrong. Kit did not include required O rings or packing for low speed adjustment needle.
denns the menance
Reviewed in the United States on January 19, 2024
I sold the motor,so I didn't use but looks good.
Master
Reviewed in the United States on August 9, 2020
‘79 Evinrude 15 hp, fit well. Viton carb bowl gasket is good quality and better than the varnish stiffened fiber gasket I removed. When installing the seat the threads began to bind and felt like it would’ve stripped if I had kept going. Grabbed the old seat and the threads went to bottom like they should, so the new seat was machined wrong. No big deal really considering the quality of the other parts appears to be right in line with OEM, just be careful not to strip the threads on a $60? carb for a $.50 seat.
Drew Grant
Reviewed in the United States on July 12, 2020
Gaskets are good quality, float feels cheap, but I do not expect it to have any issues, since it is in an enclosed space where it will only encounter fuel. The seat for the float needle has the wrong threads and cannot be used unless you rethread either the seat or the carb. Everything else is as good as OEM. Would buy again.
Richard Otto
Reviewed in the United States on July 1, 2018
I ORDERED TWO OF THESE KITS AND BOTH HAD THE SAME PROBLEM. THE BRASS SEAT FOR THE FLOAT SHUTOFF VALVE HAS THE WRONG THREADS. I THINK THEIR METRIC, HOWEVER I I RETHREADED THE FITTING AND USED SEALANT ON THE THREADS IT WORKED. WHAT SHOULD HAVE TAKEN 5 MINUTES ENDING UP BEING OVER AN HOUR AND PLUS A NEW DIE TO RETAP THE FITTING. P.S. YOU CANNOT USE THE OLD BRASS SEAT BECAUSE THE NEW FLOAT VALVE (MOVABLE PART) IS A DIFFERENT LENGTH MATCHED TO THE NEW SEAT. WILL NOT PURCHASE AGAIN!
woody wood
Reviewed in the United States on December 18, 2018
Worked great...no problems
Recommended Products
