Shopping Cart

Your cart is empty.

Your cart is empty.

3M Scotch-Weld Epoxy Adhesive DP110 Gray, 48.5 mL

4.3 (5) Write Review
Free shipping on orders over $29.99

$37.63

$ 18 .99 $18.99

In Stock

About this item

  • Flexible, fast-setting, two-part epoxy adhesive that works well on a variety of substrates, including metals, ceramics, concrete, composites, wood and many plastics.
  • 7-13 minute work life(depending on workshop temperature). About 20 minutes to handling strength @ 72F. About 48 hours to full curement.
  • EPX system that is portable. Unused portion re-closable. Viscosity @ 72°F (23°C):40,000 to 90,000 cps.
  • Aluminum Overlap Shear @ 75F: 3500 PSI. . Aluminum T-Peel: 20 lb PIW. Overlap shear on abraded metals, plastics, and rubber: From 2300 to 2600 PSI
  • Dielectric Strength (volts/mil):470. Volume Resistivity (ohms - cm):6.9 x 10. Shore D Hardness (approx.): 45.
  • For industrial/occupational use only. Not for consumer sale or use


3M Scotch-Weld DP110 gray two-part epoxy adhesive is compatible with ceramic, fiberboard, glass, metal, plastic, rubber and wood materials with a 48 hr cure time. Provides a 10 min working time. Works in a mix ratio of 1:1. Delivers great performance with a shear strength of 3500 psi and peel strength of 20 piw.


Tyler Hopper
Reviewed in the United States on September 30, 2024
This epoxy adhesive works well, but the size really threw me off—it’s way smaller than I thought it would be. Make sure to double-check the volume before ordering!
LNK
Reviewed in India on October 30, 2022
He did not join two stainless steel pieces as promised in the literature. I am quite disappointed. It is not up to scotch standard.
Elliot Berg
Reviewed in the United States on March 18, 2015
Good stuff, used this for automotive butterfly valve repair. Very viscous, almost impossible to use without the specific applicator. Would recommend using the metal applicator. I broke the plastic one due to the amount of pressure needed to get the epoxy to exit the tube.
andrewwynn
Reviewed in the United States on December 26, 2013
like the previous review mentioned, the viscosity of this material makes it likely to break the tabs if you use an inferior applicator that doesn't hold the nozzle due to the tremendous pressure built up when the epoxy starts to set up.Get the proper applicator: automix heavy duty 2oz. (all metal, holds the nozzle with a steel strap).-awr
Liudvikas Bukys
Reviewed in the United States on October 19, 2010
Those side-tabs (holding the applicator/mixer on) snap off or loosen way too easily.Once that happens, you don't have a seal between the duo-pak and the applicator, and a big mess leaks out all over before it can go into the mixing tube. You'll end up pushing out all the exopy and hand-mixing it, which defeats the purpose of the fancy applicator.So keep the pressure low, and/or use your second hand to push the applicator onto the duo-pak constantly so it doesn't push out and break the flimsy tabs.Great concept for mixing, but the duo-paks should a thicker and/or metal tabs on them.