Your cart is empty.
Your cart is empty.
Feature:
1. Non-contact magnetic induction angle measurement module.
2. AS5600 magnetic encoder high precision, a variety of output modes: IIC , PWM and voltage.
3. The angle measurement sensor module adopts exquisite technology, high sensitivity, and will not appear the problem of poor contact.
4. Made of high quality material, the module is durable and has long service life.
Parameters:
VCC: 3.3 V
GND: Power Ground
Out: PWM / Analog output voltage
DIR: Rotational direction (ground=Value increases clockwise; thenVCC =Clockwise values are decreased)
SCL: IICThe communication clock line
SDA: IICData communication line
GPO: Mode selection (internal pull ground=Programming modeB)
Specification:
Color: As pictures shown.
Size: approx. 23x23mm(0.91x0.91in)
Package includes:
4 x AS5600 Magnetic Encoder
Note:
1. Please allow 1-3cm error due to manual measurement.
2. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
P. Meyer
Reviewed in the United States on March 3, 2022
To enable analog output you must remove resistor R4 - it is pulling pin 8 (PGO) low and that enables ‘mode B’. Once it is removed the pin floats high and analog output works as expected.
Fernando
Reviewed in Mexico on April 25, 2022
Me pareció excelente el circuito.
Recommended Products
$11.79
$ 5 .99 $5.99