Your cart is empty.
Your cart is empty.Product Description
STEPS FOR USE
Dissolve each buffer solution in 3 beakers filled with 250 ml distilled water and switch to pH mode.
1. Unplug the protective cap from the electrode, switch on the product and place it in the solution to be measured, then measure;
2. Touch "MODE" to toggle the desired function in ph or ppm mode, when the value is stable, touch "HOLD" to lock the value and read the value. Long press "TEMP" to change ℃/℉ ;
3. For calibration, long press "CAL" to enter automatic calibration mode, the product supports three-point calibration ----- 6.86 + 4.00 + 9.18 Automatically identify the calibration solution and calibrate automatically.
5 in 1 PH Meter for Water
- Automatic temperature compensation
- Two-tone digital display
- Automatic calibration
- Temperature unit conversion
- IP67 waterproof
- Backlit LCD display
5 in 1 PH Meter for Water
Why buy the 5 in 1 PH Meter for Water?
High accuracy over a wide measurement range
Automatic temperature compensation
Automatic calibration
10-minute auto shut-off function
Backlit digital LCD display
Temperature unit conversion
IP67 waterproof
Calibration powder (3 packs in total)
Not only does our ph tester have five functions, it's also cost-effective: you no longer need to use pen and paper to record.
Moises C. Gonzalez
Reviewed in the United States on March 10, 2025
This unit it's working really good I will recommend
Chad Okeefe
Reviewed in the United States on September 29, 2024
I use this every day to check temp, ph, salinity percentage, ppm, ppt.I ever really have to rinse it off or anything! It's accurate and quick! Also has a lighted display and cover.
Yamis
Reviewed in the United States on August 24, 2024
Everything working like should!! Great product !!
william fagan
Reviewed in the United States on October 22, 2024
fast shipping
Maxwell McAllister
Reviewed in the United States on September 17, 2023
I had Ph strips. Unless. This is quick and easy.
Faraz S.
Reviewed in the United States on December 21, 2023
To caliberate the pH, you need to prep 3 solutions and all of them need to be at the exact 25C temperature... that takes a lot of time to get right. I did all that, then tested the pH meter in distilled water. It gave me 5.5 pH reading, which is pretty much impossible!I should add that the temperature and TDS readings on this meter were also way off from another meter that I bought on Amazon. I have no idea which, or if either of these are (more) accurate.
Norberto Esteves
Reviewed in the United States on November 6, 2023
This Meyer works as it should. Would recommend
EazyE
Reviewed in the United States on November 11, 2023
Product works as it should. No complaints.
Recommended Products