Your cart is empty.
Your cart is empty.Crystal Hackney
Reviewed in the United States on February 9, 2024
With these they would have worked fine however I was too afraid to use the wires because they didn't match up with the colors in my car. So I had to take the wires out one by one they have a small metal clasp that clicks into place for each wire that you can't see inside the plastic. If you do this it can be a pain and you have to be extremely careful not to mess up the connecter itself. I would have given 5 stars however they should tell you to check and make sure the wires are the same color as the ones they use on the connector and if it's not the same color if connecting them to the wires that aren't the same color is ok as long as you make sure each wire is wiring to the wire in your car. Like their are 4 wires so making sure that 1 to 4 starting left to right lines up exactly with the ones on the harness. I couldn't find this answer anywhere. So I did what I could.
Customer
Reviewed in the United States on September 21, 2022
Just needed the connectors themselves and not the wiring. Perfect match to replace brittle and cracked ignition coil/spark plug wire connectors on 2008 rav4 v6 and 2011 scion xb both (and probably a lot of other toyota models). Good videos out there on how to just replace the connectors without having to replace the wiring. Much easier than replacing the wires especially if the wires still good and its just the connectors that have cracked or broken.
Chandler
Reviewed in the United States on July 21, 2022
You can remove the wire that came with this plug and connect it to your oem wiring off the car.
Recommended Products