Your cart is empty.
Your cart is empty. Carburetor Fits 791230 799230 699709 20hp 21hp 23hp 24hp 25hp Intek V-Twin
799230 Carburetor for John Deere L111 L118 L120 LA120
When not working well: 1, oil circuit problem: fuel tank to carburetor oil supply is not smooth. Check whether the oil circuit is open, whether the tubing is choked or not, and whether there is foreign matter blocking.
2, the idle speed is too low: the new carburetor can not match the machine completely, and the old machine may need higher idle speed because of the aging or wearing of various parts. The new carburetor is based on a brand-new machine matching test, the test parameters are qualified after the factory, unable to meet the needs of each customer's different parameters. This situation needs to increase the idle speed: the valve screw at the red circle arrow (clockwise adjustment of 1-2 rings)
3, the negative pressure hole is blocked: the negative pressure hole is blocked also cause the extinguishing situation. Check whether the negative pressure hole in the red circle is blocked when it is installed.
James Rowe
Reviewed in the United States on March 22, 2025
Fast delivery, excellent product, accurately described
ronald p.
Reviewed in the United States on August 13, 2024
It mounted right up without a problem and started right up too! Everything in the kit fit well except the plugs, but ran like a top!
Taylor C
Reviewed in the United States on July 22, 2024
Direct fit, no issues. Started and runs fantastic. Great deal for what you get 👍
Amanda Parish
Reviewed in the United States on May 26, 2024
Bought this kit for the carb and gaskets. Carb sits on intake manifold w/ an arch between the carb and manifold. Nothing about this sits flush. Even if it did you'll be hard pressed to get the correct gaskets. The ones that ship are no where the thickness of the OEM parts. Do yourself a favor and buy authentic B&S parts for your B&S engine. You'll save time and frustration in the long run.
Brandon
Reviewed in the United States on November 22, 2024
Seemed to not wanna dial in perfect but worked ok
Jim Bannister
Reviewed in the United States on October 12, 2024
This carb cured my piping and back firing problems. Never could figure out the problem with my old one.
Jesse E
Reviewed in the United States on January 31, 2024
Went on a D160 24HP engine. I think the entire package is good. The choke seems flimsy compared to a different aftermarket carburetor, meaning it seems unstable and can rotate like 270°. The paper gaskets had to be cut and rounded so the shutter could open and close completely.
Customer
Reviewed in the United States on June 16, 2020
Once installed, it did the same thing the original carb was doing. It would only run on choke. It turned out that the inside of the fuel line attached to the gas tank had dissolved into a goo and clogged the line after 17 years. I had never seen that before in 30 years. So, I recommend checking the fuel supply while testing. The old carb had bad O rings and oem pieces would cost more then the cost of this package. I am happy with the purchase.The spark plugs did not fit. The thread diameter is smaller than what a 21 HP Briggs uses and they use an 11/16" socket. I can't remember using 11/16" socket to remove a sparkplug in my 30 years either. I will have to research to see what the plugs are for.
Recommended Products
