Your cart is empty.
Your cart is empty.Product Description
8MILELAKE 18pcs Injector Remover Puller Set Compatible for VAG VW Car Repair Garage Installer Tools Kit
The fuel Injector puller extractor kit is not suitable for diesel engines.
It is suitable for petrol injectors found in VAG vehicles covering 1.4, 1.6, 1.8, 2.0, 2.7, V6, 3.0, V6, 3.2 V6, 3.6 V6 and 4.2 V8 FSI engines, compatible with Volkswagen, Audi, Seat, Skoda and other similar European car engines.
Materials： Chromium Molybdenum and S45C Steel
Professional Quality： Chemically Blackened finish
Product Content
1x ball-type insertion adaptor
2x 23x76mm large cup type FSI puller
1x 14x40mm small cup FSI puller
1x 19x20mm two-leg thin FSI puller
2x 12/13mm ID x 40mm L cylindrical adaptors
2x 27x4mm & 35x7mm tapered cone adaptors
3x 24mm knurled stepped adaptors
1x 15x10mm threaded cup pulling adaptor
1x 10x8mm threaded cup pulling adaptor
1x 19mm OD x 12mm ID x 12mm L spacer bush
1x slide hammer puller
1x 9.5mm disconnect key
1x carrying case
Scott Ennis
Reviewed in the United States on September 1, 2022
I modified/fixed the product to get the job done of installing new Teflon rings on a 2.0l TSI engine. This tool is supposedly compatible with this engine. The injector tip width is approx 7.5mm, and the smallest die which should resize the Teflon seal was only machined at 7.15mm, meaning it woukd not slide over the injector to resize the seal. The other two dies were blatantly not for this specific injector and were far too large. Luckily being aluminum is was able to overdrill the die to 7.55mm and complete the job. If I didn't have a drill index by 64ths, the tool would not have functioned.
Peter
Reviewed in the United States on March 15, 2022
I only used the tools to install and seat the plastic seal. The tools found elsewhere on Amazon cost as much as this kit.
STEIN
Reviewed in the United States on November 27, 2019
Kit had everything I needed to pull and replace O rings and Teflon seals on my 2013 Tiguan. Many more tools than I needed but I bet this toolkit is suitable for many others vehicles.
Dennis Lovejoy
Reviewed in the United States on March 6, 2018
Shipped out quick , tool did ,work for what I bought it for , machine work lacked in quality
William Smith
Reviewed in the United States on March 5, 2018
Tool worked perfectly. Did everything it said it would per the description. Definitely would recommend this.
A. Goddard
Reviewed in the United States on February 16, 2018
For the price, this kit is great. worked perfectly to replace injector Teflon rings on a 2012 Audi Q5 with the 2.0 TFSI. The large tool with the black ball on the end was invaluable for installing the injectors back into the rail since they require quite a lot of effort.
Luis Cendejas
Reviewed in the United States on August 25, 2017
This kit will do the job for your FSI or TSI VW injector reseal.The cones and mandrels are not machined 100% accurate, and the brush quality leaves a little to be desired.If you can wait, and if you plan on using these tools more than once, consider spending a little extra for the factory VW kit.
Sodium
Reviewed in the United States on September 15, 2016
Perfect tool for the fuel injectors. This made swapping injectors on the FSI a snap. It's well built and will last a lifetime.
Recommended Products