Your cart is empty.
Your cart is empty.Alfa Tools hand taps carbon steel - cut thread, right hand, bright finish. Ideal for hand threading in Routine maintenance, repair work and for Rethreading applications. Taper taps (7 to 10 threads) longest chamfer insures easier starting. Plug taps (3 to 5 threads). most common chamfer, used in through or Blind holes. Bottoming taps (1 to 2 threads). used for threading close to the bottom of a Blind hole.
Farmall Dude
Reviewed in the United States on August 10, 2024
I needed to tap out one hole. This set worked just fine for that. Seems like decent quality, but I'm no machinist so I really don't know.
Gene Fudge
Reviewed in the United States on March 14, 2024
Seems to be good quality only used 1 time made really good threads
Family Man
Reviewed in the United States on September 28, 2022
Had a project of 8 holes. Broke in middle of doing the sixth one.
John Fisher
Reviewed in the United States on May 24, 2021
The rear end of these taps is domed, lacking the usual indentation used to align the tap into the hole. Basically useless! Will return them.
Kindle Customer - Warren
Reviewed in the United States on May 24, 2021
I purchased these taps to put threads in wood articles I turn (scoops, stoppers, etc.) They do a great job!
Mary Lund
Reviewed in the United States on March 14, 2020
I drilled out bolts in cast iron and retapped them. I bought 3 because I figured the cast iron would dull, but I only had to use one. I used another to make sure that the threads were correct. I would definitely buy them again.
Jerry O Neil
Reviewed in the United States on December 15, 2017
seem to be well built.. work just like they are suppose to. would buy again
Recommended Products
