Your cart is empty.
Your cart is empty.Mavis Botter
Reviewed in Canada on September 6, 2023
T these aftermarket cables are not an exact fitment to the original a.m. part numbers from John Deere. These cables are approximately inch and a half too long, and cannot be adjusted to pick up the slack that is required on the shift cable therefore, the shifting is hard, and does not engage the gears fully, and as another buyer also indicated the end angled pieces are narrow in design, which also lens itself to them coming out when there’s too much slack on the cable that cannot be adjusted for. I’m at the limits of the adjustment cables and they are still at least 5/8 of an inch too long.
Glenna Oliver
Reviewed in the United States on September 14, 2023
Has significantly smaller wire than OEM. Also has cheaply made cable ends as opposed to the better fitting cast ones of OEM. Would not purchase again.
Nellie
Reviewed in the United States on May 2, 2023
Fast shipper just as described
Dan P
Reviewed in the United States on February 1, 2023
The angled end was smaller in diameter than the original, but worked perfectly.
Recommended Products