Shopping Cart

Your cart is empty.

Your cart is empty.

AUDIOPIPE

Free shipping on orders over $29.99

$14.84

$ 6 .99 $6.99

In Stock

About this item

  • 0 Gauge wire reducer
  • Deep wire recesses
  • Oversized set screws
  • Ultimate power delivery
  • Platinum finish


Clean up any car audio install with these Audiopipe 0 gauge wire reducers!

These Audiopipe wire reducers have deep wire recesses, and over sized set screws for easy install.

The platinum finish gives you a nice clean look.

Made of high quality materials which delivers the ultimate power delivery.


Basshead
Reviewed in the United States on August 27, 2022
These work great and fit in amp good
ERIC SMITH
Reviewed in the United States on February 11, 2022
Great product fast shipping
Michael Sagers
Reviewed in the United States on October 3, 2022
I mean, these little things are great I must have for any serious installer given your work a nice finish look.
a wALtz
Reviewed in the United States on April 3, 2020
Great price look good, there a Nice sturdy adapter, they clam the wire nice, not Shure if they are slightly oversized or the amp lugs are a smidge small but I had to grind them alittle to get them to fit in the lug but it was a minor inconvenience, I think the amps lugs were slightly undersized.
Selena P Moretz
Reviewed in the United States on December 3, 2019
They don’t fit the audio pipe amps out of the box had to file down some material on the sides but they work now
Ashley F.A.R.
Reviewed in the United States on December 20, 2019
I read reviews about how much larger the diameter of these adapters are over the size of the 12v plug. I thought I’d be fine since I’m buying 0gauge adapters from Audiopipe for an Audiopipe amp. I was wrong. I had to take a substantial amount of material off the plug before it would go in the amp. I have a few other complaints but this size issue pissed me off. I could have just soldered a smaller wire on to my 0g.
Connor Hayes
Reviewed in the United States on April 23, 2019
Very beefy reducers. I figured that audiopipe would at least make reducers that actually fit their own amps. Still, I should of double checked before buying. I just used an angle grinder to shave them down a bit. They fit fine after that.
cody matthew kellner
Reviewed in the United States on October 4, 2018
They're definitely nice quality... Milled very nicely but there is so much extra metal on this thing that is not needed... You can definitely fit something bigger than 0 gauge in their... And easily shave off half the Exterior of it To make it fit In a lot more varieties of amplifiers ... And on a second note It says that it fits into 4 gauge but in my opinion this is also a lot!!! bigger!!! than a standard 4 gauge.... For a FYI look at my picture for size... 1 1/4inch from outside of one pin to the other and 1 3/4inch outside at the other end