Your cart is empty.
Your cart is empty.Gauge Works provide a clean, smooth way to mount gauges. Models are molded in black RevoTech plastic to prevent fading and cracking, ready to be painted to match the interior or custom color scheme.
feltennova
Reviewed in the United States on September 29, 2024
Purchased April 2024, reviewing September 2024.Bought this Auto Meter factory-style console gauge pod for my '69 Nova. I'm just not a fan of the rectangular gauges Chevy used back then and find the round gauges much more appealing. IMO they are easier to read too.This gauge pod fits the old original GM console reasonable well. I don't think Auto Meter could had done any better given that the console is some 50+ years old now. It likely is a little misshapen due to age, so the small fitment issues I'm seeing are to be expected. There is a gap on two sides, but I do not think it is Auto Meter's fault. I'd love it if it fit perfectly, but when mixing old and new parts, I do not believe that is a reasonable expectation. Your results might be better, or if this pod was used with a new reproduction console, it might fit better. Overall, I'm satisfied with how it fits.The finish of the part is very good. There are no discolorations or swirl marks in the material from the manufacturing process.Only complication with using this pod is mounting the gauges in it as the bracket that come with the gauges will not fit without some work. This was expected, so I have no complaints with having to put some time and effort into modifying the mounts. The gauges fit the holes just fine, nice and snug, so no worries there. There is just limited room on the backside for the typical mounts that sandwich the gauges in the holes.I am happy with this gauge pod.
Filipchuk’s
Reviewed in Canada on June 19, 2022
Liked it looks great in my 68 camaro
Drea Mitchell
Reviewed in the United States on October 30, 2021
Narrow with gaps on side
William Cutler
Reviewed in the United States on October 27, 2021
It fit's the center console of a 1968-69 Camaro fine. But I installed Auto Meter gauges in it and the clamp/ bracket that comes with the gauges will not fit inside this piece to hold the gauges in place. I had to cut half of the clamp off to be able to tighten the gauges to this. And it doesn't completely hold them tight. I might need to glue the gauges to this housing. Once installed it looks good.
Scott
Reviewed in the United States on May 21, 2018
Very sharp looking. Great improvement to aftermarket gauges.
Kent Molberg
Reviewed in Canada on February 22, 2018
The rings to secure the gauges don't have enough room to tighten up. Requires modification. May be different if you use auto metre gauges.
Derek
Reviewed in the United States on November 28, 2017
Holes did not have the right diameters of like it said and was missing screws to hold it down. I won't buy it from these guys again.
LivtheDream
Reviewed in the United States on November 15, 2015
Hard to see the back 2 gauge faces from drivers seat. Fit and finish is fine.
Recommended Products
$89.99
$ 43 .99 $43.99