Your cart is empty.
Your cart is empty.Florence Balfoort
Reviewed in the United States on February 5, 2025
Hubby says it fits perfect!
Kindle Customer
Reviewed in the United States on January 5, 2025
Product exactly as described.
Ivor
Reviewed in Canada on January 14, 2025
Great protection for hood tail gate and doors on my car.
William H Boyd
Reviewed in the United States on September 9, 2024
na
j
Reviewed in the United States on May 7, 2024
I like the fact I was able to find this stuff on Amazon, because I could not find it locally. Well, one place had it, but they wouldn't sell direct to me, I would have had to go to their vendor, and the vendor wouldn't sell anything to me under a 100ft roll. I only needed about 30ft. To replace the seals on my truck cap windows.The only thing I didn't like is the tape they use. I work in the rv industry, I've prepped windows before. In the rv industry you'd use pro-bond to clean your windows before installing this bulb seal. I used 70% rubbing alcohol to prep them and it still didn't want to stick. Change the tape you use to a 3m or high temp tape and you'd get a 5 star out of me.
Robert Green
Reviewed in the United States on March 10, 2024
This seems to be Exactly like ARE Covers uses on their camper top edges. After cleaning all old adhesive off I wiped withbrake clean. Lightly sanded edge, wiped again then appliedone continuous molding all the way around. 3M tape holds great!
Bob
Reviewed in Canada on February 6, 2024
As described
Colton Barrier
Reviewed in the United States on December 28, 2024
I was looking for a trim with adhesive to cover the edge of my trucks tonneau cover. Very easy to manipulate but not too easy, sticks well and looks great.
TJA
Reviewed in the United States on December 24, 2024
I used a heat gun to make a turn with this molding. It worked fine for a few days but it wants to straighten out and lift off the surface. I had to remove it and throw it away. Instead of a vinyl material, I went with rubber. That worked well.
Don
Reviewed in the United States on November 19, 2024
I bought this to cover the joint between the instrument panel and the boot cowl on the plane I’m building. Works great, looks fantastic, and the glue STICKS.
Robert Klowak
Reviewed in Canada on March 27, 2023
I found this product too small for wheel well openings as they show . It should be at least 1/2” wider on the outside
Recommended Products