Your cart is empty.
Your cart is empty.
- This Hand Lever Control Valve is 5 way 2 postions type, plastic covered handle.
- Hand Push Pull Mechanical Valve. Mechanical valves are reversing valves controlled by external manual force. Normally used to control the output signal of pneumatic systems.
- Used for controlling pilots or diaphragms of larger valves or small cylinders or any pressure system that is alternatively pressurized and exhausted.
John Diaz
Reviewed in the United States on January 2, 2025
Sin problemas.
ramiro castaneda
Reviewed in the United States on April 2, 2024
I LIKE IT
D. Annett
Reviewed in the United States on September 20, 2022
leaks like a sieve, doesn't hold position.
arturo gonzalez
Reviewed in the United States on May 6, 2021
Leaked as soon as I got it
Joy H.
Reviewed in the United States on April 1, 2021
Using this valve to control a double acting air cylinder is very difficult because the three valve positions are not defined. It will not allow you the ability to move (either direction) and precisely stop. It is loosey goosey leaving operator virtually reckless.
Richard L. Schmier
Reviewed in the United States on April 16, 2020
Has massive internal leakage making it 100% useless. When the lever is in the neutral (off) position the valve flows almost as much air to one side or the other as if it was flipped open.Looking inside the valve I can clearly see that the seals on the shaft are too far apart to properly seal in the housing.There is no excuse for the parts to be so completely incompatible with each other.This is cheap Chinese junk. I should have known better.
Recommended Products
