Your cart is empty.
Your cart is empty.Brass Clutch Pivot Pin Replacement for BMW Manual Transmission Cars.
Ariana Acevedo
Reviewed in the United States on March 2, 2025
Doesn’t fit in the hole and then once you “tap” it in it is not longer round
Hc3
Reviewed in the United States on August 24, 2024
Fits great, works good.
John A
Reviewed in the United States on July 26, 2023
As others have said, the shaft is too big. I used a grinding stone to turn it down to the correct size with no issues though. It seems to be of otherwise good quality. In this case, size matters.
George Davis
Reviewed in the United States on July 25, 2023
Great product...
Customer
Reviewed in the United States on April 18, 2023
This is a good replacement for the plastic one BMW uses. My car had 67k on it and the plastic was very worn. I expect this to last a very long time. The only issue I had was this fits tight. I put mine in the freezer for about an hour and then installed it. Aside from that it works well.
Stefan
Reviewed in the United States on September 16, 2022
It was a VERY tight fit. It needed quite some persuasion and slight sanding to be properly seated. But the part is good quality and well made.
Joseph Devin Mack
Reviewed in the United States on November 7, 2021
Used in my E83 X3 as the other plastic one was cracked I noticed when I changed my clutch. Since of security a metal one being there since i upgraded the clutch.
TXRX
Reviewed in the United States on November 11, 2021
Use a little WD. i already had installed the plastic one .. and had 2nd thoughts. You can pop the plastic one out with a socket ,an extension, and a hammer
Recommended Products
