Your cart is empty.
Your cart is empty. Fit the following Troy-Bilt models:
TB4BP (41AR4BPG966) Blower
TBP6160 (41AD616G966) Trimmer
TB4BP (41BR4BPG966) Blower
TB4BP (41CR4BPG966) Blower
TB4BPEC (41AR4BEG966) Blower
Replace MPN: 753-05676A
Package list:
1x carburetor
2x primer bulb
1x gasket
1x 2feet 6617 fuel line
1x fuel filter
1x spark plug
emptydown
Reviewed in the United States on May 2, 2024
I recently bought a used Troy-Bilt TB4BP EC backpack blower that would idle but not throttle up. I tried cleaning out the old carb and adjusted valve clearance that was out of spec but that didn't solve the issue.I adjusted this new carb to roughly match the idle setting on the old carb before installing.I put this new carb on, primed until I had fuel in the bulb and it started right up. It idled well and now works as it should! No complaints here!
Carmen
Reviewed in the United States on October 13, 2024
It was the right one it works great but it said it was ship to me the next day and it wasn't two more days
SZig
Reviewed in the United States on January 16, 2024
Great value. Worked well. Leaf blower runs great now.
Jim Rau
Reviewed in the United States on July 7, 2023
the kit is easy to install and provides all the necessary parts, but the unlabeled spark supplied with the kit will not work correctly in a Troy Bilt 4-cycle blower. It needs a DZR3U spark
Claude
Reviewed in the United States on November 23, 2023
This was a very smooth transaction, not only were the pictures a huge help in determining that this was the correct part, the part numbers were clearly defined so I purchased with confidence and had exactly the right part. Shipping was very fast as I had part the day after order. Would highly recommend this company.
Random dude
Reviewed in the United States on September 16, 2022
Super easy install.. 5 minutes? Bought the non-running TB backpack blower for TEN BUCKS at a garage sale, got it to start but no throttle response. Then a few weeks later, couldn't keep it running for more than 10 seconds. Slapped this baby in and BAM! STARTED FIRST PULL. No joke.Tip: eyeball the silver screw (idle) with the other one you take off...I had to turn mine in quite a few turns but apparently I nailed it. Ran it for 15 mins or so, took a quick break, choke in #2 position, BAM! Started first pull again!! Replaced the fuel lines, drilled out the hole in the gas tank a tiny bit because it's TIGHT. Way too tight. I didnt swap the spark plug, but it did come with one. Some other random dude on here said it was the wrong one anyway and wanted to troubleshoot as I went. No need because my blower runs like Forest Gump now. Recommend it!
Ron El Dorado Hills
Reviewed in the United States on May 31, 2022
The carburetor is a perfect fit. Had to trim a little of the gasket/insulation wall on the machine so that I could get the new gasket in the kit in place. The carburetor is incredibly easy to adjust. Since the kit came with a new spark plug I decided to go ahead and put it on even though the old spark plug was not that old. Put on the new fuel filter. The leaf blower fired right up but ran incredibly rough and quit. After several attempts, and after replacing the fuel to make sure it was fresh, I decided to put the old spark plug in. The machine now runs perfectly. The spark plug from H&H that comes with the kit is not made for this leaf blower. The only other shortcoming of the kit is it did not come with a new air filter. Since they are so cheap it could've easily been included.
Chopper
Reviewed in the United States on April 20, 2022
Buy this if you need a new carb for your Troy Bilt TB4BP back pack blower. Original was a Walbro. New carb has fuel line connections below the primer (original were above), which is no problem as they are closer to the fuel tank. It makes zero difference. BTW, on the TB or MTD site, the OE carb now has connections exactly like this. There is no taking the carb apart to make things fit like some have done. Rubber O ring on the air filter side is included. It works out of the box. With new fuel lines and filter, the machine started up easily. How long it lasts is unknown, but more than satisfied.
Customer
Reviewed in Canada on December 13, 2021
Product works but design is different than one it replaces. One of the fuel inlets is in a different spot so might be a tricky install for some applications.
Recommended Products
