Your cart is empty.
Your cart is empty.Product Description
- Fit CDH 2 stroke YD100 and LD100 Engine Only.
- The connecting rod marked "YD100"
Balanced crank
Length of connecting rod is 116mm, hole to hole length is 88mm
Top side hole diamter (for piston) is 14mm.
Bottom side hole diamter (for crank) is 22mm.
- Fit CDH 2 stroke YD100 and LD100 Engine Only
- The connecting rod marked "YD100"
- Package Included: 1 x Crankshaft
- Note: Please check the size for compatibility before ordering it.
Badhabit
Reviewed in Canada on May 3, 2024
Poorly packaged
two stroke Lew
Reviewed in the United States on October 12, 2024
quality is good. I true my cranks on the lathe then balance them better by drilling a 7/16 hole 7/16 deep beetween the other 2 holes.it was a bit wonky but most are.
chris
Reviewed in the United States on April 6, 2024
Exactly what I ordered. Didn't expect a lot of play in the piston shaft. But there was a lot more than I thought there should be. YD100 you would figure would have tighter tolerances. There was some Rust on the flywheel but I guess coming all the way from China on a boat you would expect something like that. They probably send hundreds or maybe even thousands of these to him America. And you got to expect a little rust. But my luck of the draw gave me a little play in my piston shaft and rust on the flywheel lucky me. They probably crank out hundreds of these daily and no one checks for Quality anymore. I'm going to take it to a machine shop to have him balance the crank. And tighten up the tolerances just a little before I build my new 100cc 2-stroke. I'm thinking of this as a blank for my project. But as they say you get what you pay for.
Recommended Products
$108.50
$ 47 .99 $47.99