Your cart is empty.
Your cart is empty.Marlene Shifrin
Reviewed in the United States on February 9, 2024
A guy who professionally builds, wires, assembles & repairs racks that house electronic equipment has strongly advised me not to drill & tap holes in the necessarily nearby metal. Otherwise, I could've damaged any or all of the above. This is why I'm returning these items.I apologize to the seller.
Casey
Reviewed in the United States on March 5, 2019
Used to it tap a Mosin receiver and a couple other things as well. Can confirm it works on steel as well as brass and is very sharp. Barely any effort needed to tap.
Jim in CA
Reviewed in the United States on November 22, 2018
I used it to tap 12 holes in 4mm carbon steel strip stock for a project. It seemed to cut nice clean threads with no problem. No problem installing the set screws afterward.
Brock & Jess
Reviewed in the United States on October 31, 2018
broke my carbide tap ( rolled of the work bench) bought this to replace it hoping to get it fast, but some how got delay 10 days....
12lives
Reviewed in the United States on March 14, 2017
Nice and sharp - cut nicely into steel and cast iron.
Recommended Products