Shopping Cart

Your cart is empty.

Your cart is empty.

Chrome 12' Rise Ape Hanger 1.25' Handlebar Fits For Harley CVO Road Glide Street Glide Tri Glide Electra Glide Road King Dressers Baggers 1982-2023

Free shipping on orders over $29.99

$84.99

$ 34 .99 $34.99

In Stock

About this item

  • Condition: Aftermarket 100% Brand New. Color: Chrome. Material: Iron.
  • Rise: 12", Bar Diameter: 1 1/4", knurl Center-to-Center: 3.5", Clamp Area Diameter: 1", Center Width: 13.58", Grip Area Bar Diameter: 1", Width from Tip to Tip: 37", Pullback: 11.42"
  • Fit For Harley-Davidson Touring models, Dressers, Baggers, FLHT(Electra Glide ), FLHTC from 1982 to present including. May work on throttle-by-wire models with custom fitting and any custom application. Note: DOES NOT Fit for Road King & Road Glide Models. Buyer needs to check the application according to the measurement above.
  • Fit for Harley FLHT Electra Glide Standard 1982-2023; Fit for Harley FLHTC Electra Glide Classic 1982-2023; Fit for Harley FLHTK Ultra Limited 2010-2023; Fit for Harley FLHTKL Ultra Limited Low 2015-2019; Fit for Harley FLHTCU Ultra Classic 1982-2023; Fit for Harley FLHX Street Glide 2006-2023; Fit for Harley FLHXS Street Glide Special 2014-2023
  • Package Included: 1 x Handlebar (As Picture Shown)



breton
Reviewed in the United States on January 28, 2025
Like candle bars fit well worked good
c jones
Reviewed in the United States on March 18, 2022
It went on the Ultra Glide and fitted perfectly. I am a satisfied customer.
Jeremy Fifield
Reviewed in the United States on September 6, 2021
I think this product is good.. Nice chrome
RANDY N.
Reviewed in the United States on August 8, 2021
It worked out well for me I like them nice Chrome easy to fish the wires through
Chadloehr666
Reviewed in the United States on August 7, 2021
Nice beefy bars for the price. Had to order brake line to fit my 04 ultra brake line I ordered generic 45.75 inches sweet wider stance now thou
Jason
Reviewed in the United States on August 20, 2021
Everything works as it should however there are no reliefs for hand control wires... with some fabrication you can make them work as i did. Was no point in calling for return as i was already half way through swap before i noticed this... oh and the wires a pain to pull through this design so prepare for some time and a bit of a battle.
Matt Ryan
Reviewed in the United States on March 4, 2021
Had to send them off because the welds was not welded right can’t get ahold Of the company
Michael N.
Reviewed in the United States on April 28, 2021
My only issue was that where they had notched the right hand side (assuming this is done for a throttle by wire, which mine does not have)had flared out probably because of the heat warping the steel while it was cut, this was solved with some love taps from a hammer . I am welder/fabricator by trade and am honestly surprised that the work is decent in comparison to the price. Just be aware that you may encounter new issues that may have you reworking the part a bit, this is okay with me because comparable bars would be 2-3× the price of these.