Your cart is empty.
Your cart is empty.
Description:
100% new and high quality
Name: High Voltage Diode
Model: PRHVP-20
Reverse positive anode voltage: 20KV (20kV)
Forward average rectified current: 750mA
Maximum forward surge current: 50A
Maximum positive axial voltage: 20V
Improved HVP-12: 14: 15: 16: 20, etc. It has high voltage resistance and high current characteristics, and is widely used in high frequency machinery and other large current rectifier power circuits.
Color : As the picture
Quantity:4Pcs
Features:
1. High reliability
2. Excellent anti-surge impact capability
3. Large area PN junction, low forward voltage drop (Vf)
4. Junction temperature: -40 ~ + prefix = st1ns = "urn: schemas-microsoft-com: office: smarttags" 150 degrees
Note:
Light shooting and different displays may causethe color of the item in the picture a little different from the real thing.The measurement allowed error is+/-1-3cm.
We highly appreciate all custome rsopinions to improvethe selling, also if anything you unsatisfied, please contact us for probable best solution. Thank you!
Package Included:
4Pcs 20000V 20KV 2A PRHVP 2A-20 Single Phase Rectifier High-Voltage Diodes 18*19*75mm(If the number of products received is incorrect, please contact us. we will refund or give you a replacement.)
Joseph Eichholz
Reviewed in the United States on September 24, 2024
I use 2 for mot voltage doubler and they work great!!!
M K
Reviewed in the United States on July 31, 2024
Diodes do not work properly.
Radio!
Reviewed in the United States on March 14, 2024
Physical appearance and initial testing of these PRHVP2A-20 rectifiers at low voltages look good. The provided electrical connection terminals are tabs that accept commonly available 1/4 inch quick-connect receptacles. At around 70 F. room temperature, these start to conduct at forward bias of close to 12.1 volts. The forward voltage drop tops out at around 14.5 volts, a figure typical of high voltage rectifiers such as these. As another reviewer stated, the diode test function of a typical multimeter is not able to check these; due to the forward voltage being considerably higher than that of a single solid state diode junction. I don't have the equipment set up at this time to perform a full reverse voltage test on these.
Norman Charron
Reviewed in the United States on February 19, 2024
NONE of these work
Patrick N. Butler
Reviewed in the United States on February 4, 2023
Due to HV capability, the Diode will not work at low voltages. A multimeter's standard diode test will fail! use a 9 VDC battery and read the voltage drop.
Patrick Tufts
Reviewed in the United States on October 12, 2023
... and they work as advertised.. good value
Chuck
Reviewed in the United States on July 16, 2022
Bought for stock for future need.
Just Richard
Reviewed in the United States on October 1, 2021
Only tested these at 15kv so far and they held up. Building them into an 8kv working voltage full wave bridge and will see how it goes. Nice you don’t need balancing resistors hopefully this is taken care of internally in the stack.
Recommended Products
