Your cart is empty.
Your cart is empty.Product Description
Kit Includes:
- 2x Front Upper Control Arms w/Ball Joints Assembly - K622128
- 2x Front Lower Ball Joints - Driver and Passenger Side - K500232
- 2x Front Sway Bar End Links - Driver and Passenger Side - K80631
- 2x Front Outer Tie Rod Ends - ES800901
- 2x Front Inner Tie Rod Ends - EV800935
- 1x Idler Arm Assembly - K400018
Fitment:
- 2011-2019 Chevrolet Silverado 2500HD
- 2011-2019 Chevrolet Silverado 3500HD
- 2011-2019 GMC Sierra 2500HD
- 2011-2019 GMC Sierra 3500HD
Easy Installation
Detroit Axle control arm is designed to be a direct-fit replacement, easy to install, better driving and serviceability.
Premium Alloy
Premium alloy material makes the control arm highly wear-resistant and anti-rust. At the same time, high rigidity can extend the life of the product.
Enhanced Structural-Strength
High-strength structure can withstand repeated impact loads, making it more stable during operation
High Performance
Detroit Axle suspension kit is OE manufactured to meet expectations for fit, form, and function, offering high quality and great value.
Jamie
Reviewed in the United States on June 21, 2023
I had a small issue with the shipment but their customer service took care of it asap and made it right. I would definitely buy again. The products are really good quality and everything you needed came with it.
Hunter Little
Reviewed in the United States on January 22, 2023
Good product for price with good parts. After a few months both upper control arms have started squeaking due guessing maybe bushings have went dry not sure..
Gary Smith
Reviewed in the United States on September 2, 2021
These parts are as good as any everything works as it should
BML
Reviewed in the United States on October 30, 2020
April 2024 Update:My passenger side tie rod end boot has gone bad. Other than that the rest has held up well on my truck. I use it mainly for hauling and would buy this kit again. I have used this manufacturer for numerous vehicles and like the quality.Original post from 2020:Well worth the price to fix the wear parts on the front end of my 2013 GMS Sierra Denali 2500 HD. Lower ball joints were the hardest to replace. The rest of the kit only took about an hour each side. Total job was about 7 hours because I had to run out and look for my father-in-laws press kit. Steering is nice and tight and my new tires should wear even now. Make sure you schedule an alignment for the front end after install. I measured and installed and was still way off of aligned. Buy yours now and stop ruining those expensive tires!
Paul Vasquez
Reviewed in the United States on December 14, 2019
Well built parts.
Recommended Products