Your cart is empty.
Your cart is empty.Product Description
Jonathan C. Bryant
Reviewed in the United States on September 10, 2024
Replaced derale fan controller.Much cheaper and cheaper.
Dragstar kustoms Inc
Reviewed in the United States on August 16, 2024
Works just like the Craig Davies unit, drive the car everyday and it works as it should. Would probably want to invest in the in liquid sensor it's more accurate than the probe, but if you know the temps you need and understand the probe is 15 to 20 degrees colder than the actual water temp set accordingly. And yes a hot day will kick the fans on so wire correctly and expect that performance with probe use...I have this on my GMT800 chevy truck, and my bmw e60. So you see it works with any car any aftermarket fan or 12v accessories.
William Varaksin
Reviewed in the United States on July 26, 2024
This fan control is far better that my previous one! It is easy to install and turn on turn off setting is simple! No problems so far! Don’t waste your time and money on a cheaper dual fan controller! Has digital temperature readings! Awesome and dependable!
Raymond McPhillips
Reviewed in the United States on July 24, 2024
This was very easy to install and works great.
Francisco L.
Reviewed in the United States on June 28, 2024
Very very good and fast
Brent
Reviewed in the United States on May 24, 2024
Don’t waste your time trying to skimp by, purchase this kit and call it a day. It’s the easiest way I’ve ever installed electric fans and it’s simple and perfect. Ground your fans, and ground this box. Connect each fan to the labeled wires, connect power wire to battery positive, connect ignition hot and ac wire then hold down button to change to Fahrenheit then single tap until desired temperature and stick the temperature probe by upper hose in radiator fins and you’re done if I ever install fans on another vehicle this will definitely be the route I take
limited360
Reviewed in the United States on December 10, 2024
After about 2.5 months the unit is now staying stuck on for one of the fan channels. I have to physically remove the relay. I bough two replacement BOSCH relays, problem is identical.I am using this to feed a solid state relay as a trigger, so the fans are not even drawing power through this unit.Shame as it worked great for the short period of time. Back to a basic temp switch as it works!
Zacmanrules5
Reviewed in the United States on October 26, 2024
Easy to install and setup but! Sometimes it resets the temp and the fan stays on so I have to pop the hood to reset it. Very annoying. Done it 4 or 5 times since may.
Recommended Products
$10.50
$ 4 .99 $4.99
$29.95
$ 14 .99 $14.99