Your cart is empty.
Your cart is empty.This replacement cowl panel matches the finish and appearance of the original part to maintain a vehicles appearance while managing air and water flow around the cowl area. It's made of quality materials for a durable service life. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Ford Mustang: 1999, 2000, 2001, 2002, 2003, 2004]
Fred S. Biondo
Reviewed in the United States on August 2, 2024
It is a very good replacement, but the rubber seal at the windshield was too short, and the adhesive was messed up. I would as able to reuse the old seal and fix the adhesive.
John C.
Reviewed in Canada on July 7, 2024
That it fitted with ease and looks original
vester sullivan
Reviewed in the United States on July 4, 2024
I am overall pleased with this wiper cowl. I had purchased a two piece cowl but it would not fit properly. This one fit pretty good overall. The main issue I have was that the adhesion tape was very bad and the rubber pieces they hold on were found upon opening the box to not be attached in many places. I had to spend a lot of time getting the rubber pieces to hold on as best they could when installing the wiper cowl. Again, overall pleased with the product but the adhesion process is terrible.
Douglas 7
Reviewed in the United States on January 2, 2024
Well, when this arrived the box was in pretty rough shape and the rubber seals had mostly come loose. Also, I had ordered the exact part number that the body shop requested but it did not fit (not the seller's fault).So, all in all this order did not work out well. But on the positive side, the quality of the part looked good and the customer service was great - they let me return it for a full refund.
LAO0911
Reviewed in the United States on August 28, 2023
Had some difficulty getting the clips to lock in and the washer nozzels kept poping out. Little bit of super glue fixed the nozzles and now it looks near oem.
Dan in IT
Reviewed in the United States on June 30, 2023
The molded part is perfect, fits, goes in easily, unblemished. Every piece of rubber was sloppily glued, coming off, and crooked. The weatherstripping that goes against the windshield is short on both sides. If it were a little long I could cut it to fit but short just looks crappy.
Customer
Reviewed in the United States on July 26, 2022
easy install, dont waste money on the 2 piece options out there just spend the money and avoid the delay and headache.
Kc
Reviewed in Canada on June 8, 2022
For my car
Darren
Reviewed in Canada on December 18, 2022
Complete waste of money and when Covid hitI had trouble returning item .. cause of the time it took me in able to return itemVery disappointed in purchase !!
Robert H Patten
Reviewed in the United States on April 23, 2021
The factory pieces are getting very expensive and almost impossible to find. The 2 piece ones fit like garbage. I got this one and the fit and finish was awesome. Had to tweak the weather stripping a little, as the factory worker obviously just slammed it on as fast as possible and it wasn't done right.Once it was on, fit awesome and looks great.Anyone with a New Edge or SN95 Stang should consider this one.
Sat
Reviewed in Canada on April 17, 2021
The panel fit great on my 1999 mustang GT
Shawn W.
Reviewed in the United States on April 15, 2021
Installed on a 2003 Cobra after I stupidly broke my OEM one. The reviewers are partially correct.The washer nozzles will ‘pop’ in, but a very light push will pop them back out. I’ll see if they stay seated in there before I resort to gluing them down. That’s a little disappointing, but I’m not worried about them flying off completely since the hose attachment is extremely snug.My weather stripping strip was actually longer than the OEM one and had less of a gap between the end and the pillar.The fit is good. The clips and the pin holes line up well. It does not come with the push pin/screws but you can buy a bag of them cheap or re-use the old ones if you didn’t break or lose them. It does come with metal clips so you don’t have to re-use the old ones.The clips are new so you’re going to have to use some force. I made sure it was lined up and sort of lightly tapped it with the side of my fist to pop them in.Lastly, the texture is slightly different than the OEM. It think it’ll be fine. Remember this is like 1/3 the price of an OEM. I just wanted it to look good again and it’s good enough.
Luca
Reviewed in Canada on June 10, 2020
It is 95% match to OEM... You would not know the difference.. It fit in very well.. Only the window trip fell an inch too short and the rubber for hinge clearance is a tad off... Otherwise, it is a lot cheaper then OEM.. Nobody will notice the difference.. I am just a little more picky..
Recommended Products
