Your cart is empty.
Your cart is empty.New drive sleeve compatible with many Mercury or Mercruiser sterndrive or outboard propellers.
Mark W.
Reviewed in the United States on February 24, 2025
Good
RunnerRunner
Reviewed in the United States on January 11, 2025
Haven't used it... have as a spare. Seems good. Feels good..If you know you know.
Georgia Kay
Reviewed in the United States on September 20, 2024
Works as it should.
ChickenPick'n
Reviewed in the United States on September 18, 2024
Simply put, these will not work for Yamaha VMAX SHO. Yea they will fit the prob, but you can guarantee they will not hold up. The heat from the exhaust venting across them essentially degrades the material such that under the extreme torque you often apply in take-off and in turning they blow out. Spun two of these in the space of 5 fishing trips on Hartwell. Do yourself a favor and spend the extra money and buy the RBX from Solas....you can thank me later.
K. Endo
Reviewed in the United States on August 31, 2024
Worked as needed/expected; no issues with delivery.
propmanWDR
Reviewed in the United States on August 30, 2024
This drive sleeve is a great replacement for the original equipment manufactured part. It fits properly and seems to perform as well or better than the OEM part at a fraction of the cost. If you need to replace the drive hub in a propeller, and this fits your application, I would recommend this part.
ram
Reviewed in Canada on August 13, 2023
le produit est bon mais ne rentre pas dans le moyeu de hélice de moteur , car la dimension pas la bonne
Ken
Reviewed in Canada on November 1, 2023
Replacement part fit and worked well. Only complaint is it's a little pricey for just the hub sleeve compared to some of the other hub kits available on the market with washers, nuts, lock tabs etc. Still way less expensive than the local marine dealer.
Hawk
Reviewed in the United States on July 29, 2021
This is so much cheaper than taking your prop in to have it done. So easy to do it yourself.
AG
Reviewed in the United States on June 7, 2021
for my propeller , it did not slide into easy - first I thought it will not fitting (previous was getting in - out easy).I had to apply some grease and knock thing into. Guess if I need to replace, I will have to use chisel to break old one - may be your prop has slightly different inner size. But ultimately worked.Season end update - runs well for summer ... Will inspect spring time before putting into water..The other thing - outer surface can be sanded a little with electrical sander as it is plastic.
Recommended Products
$104.99
$ 43 .99 $43.99