Your cart is empty.
Your cart is empty.Edge Trim-Rubber U Channel Length 26FEET with self-Adhesive Design for car Doors, Table Corners, etc
Jeff
Reviewed in Canada on March 7, 2025
Works and looks great. Thoroughly clean door edge and use a hairdryer or heat gun to gently warm the adhesive during application.
Banff Mtn Man
Reviewed in Canada on September 12, 2024
I have an X5 where the tailgate will occasionally go up if I sit on my key fob the wrong way at home. When it lifts it gets stuck on the garage door panels and off we don’t see it and try to open the garage door, it gets caught and also the paint on the tailgate gets chipped. I ran a strip of this along the bottom edge of the tailgate - problem solved. It looks good, doesn’t interfere with tailgate operation and is robustly secured so that it doesn’t come off when it gets caught. :) Happy camper! Would also work well as door guards if you were so inclined.
JR Dorcak
Reviewed in the United States on August 7, 2024
Easy to install. Use rubbing alcohol to clean back side of door edge. Sticks way better. Looks good and really protects door edge.
Daedalus
Reviewed in Canada on August 12, 2024
Used this on the cabin hatch of our Bayliner 285 boat, looks better than the OEM one it came with and that kept falling off. Adhesive strip is not that wide but is holding well. I cleaned surface with Isopropyl alcohol to make sure there would be a good bond. Ended up with lots of extra left over. Better than expected overall.
JT
Reviewed in the United States on July 25, 2024
I ordered this to create a protective edge on top of the steel edge around the perimeter of my Hitch Haul carrie to protect luggage from being damaged by the thin steel edge of the vertical sides of the carrier. This weatherstrip was the perfect size and thickness. It arrived in a nice, neat coil. I simply measured, test fit, trimmed to length and installed. I found it was easiest to apply the entire strip, press it down firmly in place, pull off the red glue protective strip then press the glue strip against the carrier’s side. Very simple and easy install. A quality product.
Mike Katz
Reviewed in the United States on July 22, 2024
Made my windshield for the boat look good as new
Glenn
Reviewed in Canada on March 20, 2024
Easy to widen and put around whatever your using it for. The glue could be better that is under the red strip
Jennifer
Reviewed in Canada on February 24, 2024
The products seems like good quality but the u channel was stuck to itself so I had to unstick it as I was applying it. Upon unsticking it from itself, the adhesion gummed up and did not apply evenly. I think if they fix the manufacturing then it could be a great product. Had to return it.
AssemblyBandit
Reviewed in the United States on November 10, 2024
Goes on easy but will have to cut to get around some corners.
Bob Galloway
Reviewed in the United States on October 26, 2024
Better than original for my fender flares!!
Dave
Reviewed in the United States on October 12, 2024
While the edge protector was reasonably priced & easy to install, 2 issues.It didn't adhere to the inner door lip very well.After just 10 days it was very dark & dingy. A wet cloth wiped off most the grime it had collected, I'd never seen that with any other door edge protector.
Beltane
Reviewed in the United States on January 23, 2023
The rubber seems good quality for the cost. As you see in the pictures the backing for the adhesive was detached in many places but it hasn't been an issue yet. The adhesives only on one side of the channel but so far that's enough. In very tight bends it needs to be cut and can come loose so I used actual 3M two sided tape to secure it. The rubber is very flexible which is good for my application.
Jessy
Reviewed in the United States on April 24, 2023
The tape is pretty useless
Recommended Products
