Your cart is empty.
Your cart is empty. "Pipe Marker Centering Tool with 4'' Y Head, Measure Pipe Diameter 0.5'' at least, with Adjustable Dial Bubble Protractor.
Specifications:
Color: red and silver
Pattern: as picture show
Size: 6.3 x 4.1 x 1.4 inch
Package includes:
1 x Pipe center finder
1 x Hex wrench
Warm notes:
Please allow slight dimension due to manual measurement.
Please allow slight color difference due to different monitor and light effects. "
Gerardo Avella
Reviewed in the United States on February 7, 2025
Llegó dañada la burbuja
Maria
Reviewed in the United States on July 18, 2024
Muy bueno
Van Godette
Reviewed in the United States on November 11, 2024
It works as needed.
j almaraz
Reviewed in the United States on January 16, 2024
Bought the item but the level portion is not level how do you suppose to properly use if its not level. I understand that it's not the top of the line brand but come on ...
Richard E.
Reviewed in the United States on April 13, 2024
First time use, tool tipped over and bubble level fell off. Hot glued it back in place, hope it stays now.
Jon
Reviewed in the United States on August 12, 2023
The marking pin is loosened with an included Allen wrench. When loosened, the pin can fall out in either direction.The marked angles with the bubble level should work fine as long as your tubing is leveled as well. A small screw holds this in place. If it was designed so that the screw only applied tension, this would be okay. But if you turn the angle counterclockwise, it loosens the screw completely. So what you need to do is set the angle and make sure to tighten this screw.As for the angle markings. My opinion is that the markings are not precisely made. Are the angles correct? I hope so. But the marks are "fat" and not very fine--so not very precise.At the end of the day, it will be useful for marking holes and notching. Just not the ideal design, in my opinion.
CaMo
Reviewed in the United States on August 12, 2023
I ordered this for my husband who uses a center head regularly in his line of work. He says this center head is pretty good, but he would like it better if the punch had a bump to hold it in, or was spring-loaded, which would keep the punch from falling out. As it now, the punch comes out because it doesn't have anything to hold it in. That said, It can be tightened with an Allen wrench so that it won't slide out, but he feels that's an extra piece to the tool that isn't needed. Otherwise it does the job and is fairly accurate.
Dean
Reviewed in the United States on December 16, 2023
It seems like the bubble level lines are to far apart. It was had to get it to line up exactly level. Maybe I need to try it some more?
Recommended Products
$30.74
$ 12 .99 $12.99