Your cart is empty.
Your cart is empty.Create your own custom flooring materials from standard dimensional materials with these carbide cutters. designed for use with 5/8-Inch and 3/4-Inch lumber these cutters are great for designing new floors or for creating replacement planks for repair and renovation. for use on 3/4-Inch spindles. tongue and groove are below center so you can resend and finish a number of times.
Scott M
Reviewed in the United States on February 13, 2018
Setup is critical. Must run boards good side up for the under-cutting to work properly.
Gina Slack
Reviewed in the United States on March 12, 2017
This item works just like advertised
81arctic
Reviewed in the United States on February 13, 2014
Whats to say? This set works as they should. I've run about a thousand linear feet of flooring through them with no issue.
J. Dailey
Reviewed in the United States on January 4, 2014
I had flooring shorts from many suppliers. The beads and width dimensions were all over the map. Using my trusty shaper and tablesaw, everything was made to match perfectly. This cutter set performed flawlessly.
Larry R. Hutson
Reviewed in the United States on November 26, 2010
Purchased to re-work reclaimed lumber from an old granary I tore down. I removed old flooring and weathered siding from an old granary, cut off the damaged and dirty tongues and grooves, planed the wood, then cut new tongues and grooves with this set. I made enough flooring for a roughly 24 x 16 living room and 2 - 12 x 12 bedrooms, then made bead board from some of the siding to cover the ceilings in the two bedrooms and roughly 100 square feet of wainscot. This set never bogged down and kept a sharp, precision edge throughout the project. It appears to be up for whatever else I choose to throw at it. Very satisfied with the quality.
Recommended Products
